Linmore LED WAL Installation Instructions Manual

Wall Mounted Area Light (WAL) Installation Instructions | Page 1 of 2

WALL MOUNTED AREA LIGHT (WAL) INSTALLATION INSTRUCTIONS

These instructions do not purport to cover all details or variations in components nor to provide for every possible

contingency to be met in connection with installation, operation, or maintenance. Should further information be desired

or should a particular problem arise which is not covered suciently for the purchaser’s purpose, the matter should be

referred to Linmore LED Labs. Linmore does not claim liability for any installation not performed according to this guide or

not by a qualied electrician.

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION

2. WARNING – Risk of re or electric shock. LED Upgrade Kit installation requires knowledge of luminaires electrical systems. If

not qualied, do not attempt installation. Product must be installed in accordance with NEC or your local electrical code. If

you are not familiar with these codes and requirements, contact a qualied electrician.

3. WARNING – Risk of re or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for

installation of the LED upgrade kit. Check for enclosed wiring and components.

4. WARNING – Risk of re or electric shock. Check the existing wiring for damage before installing upgrade kit. Do not install

if existing wires are damaged.

5. WARNING – To prevent wiring damage or abrasion, do not expose wires to the edge of sheet metal or any other sharp

objects.

6. WARNING – Risk of re or electric shock. Install this kit only in the luminaires that have the construction features and

dimensions shown in the photographs and/or drawings.

7. The retrot assembly is accepted as a component of a luminaire where the suitability of the combination shall be

determined by UL or authorities having jurisdiction.

8. Only the holes indicated in the photographs or drawings may be made or altered as a result of the kit installation. Do not

leave any other holes open in a wiring enclosure or electrical component.

Revised November 29, 2018 4:48 PM

Linmore LED Labs | 2360 S Orange Ave, Fresno CA 93725 | 559-485-6010 | www.linmoreled.com | [e-mail]

1. Remove cover and lens.

Wall Mounted Area Light (WAL) Installation Instructions | Page 2 of 2

2. Remove (2) two driver

mounting screws and swing

driver assembly out of your way.

3. Mount xture body to standard

J-Box or directly to wall, using

universal mounting options.

4. Feed existing power through top

or rear knockouts, connect power,

connect low-voltage LED wires and

secure with supplied wire nuts and

reassemble entire xture.

GN D

RED

BLK

Linmore LED Labs | 2360 S Orange Ave, Fresno CA 93725 | 559-485-6010 | www.linmoreled.com | [e-mail]