Link Win Technology SSB554R User Manual

Model:SSB558R

2.0MPx

5.0MPx

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment. This equipment has been tested and found

to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help This device

complies with part 15 of the FCC rules. Operation is subject to the following

two conditions (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may

cause undesired operation.

FCC ID: 2AQ4G-SSB554R

The EUT was tested and rated under the American National Standard Institute (ANSI) C63.19-2011

hearing aid compatibility standards. The ANSI standard for hearing aid compatibility contains two types

of ratings:

· M-Ratings: Rating for less radio frequency interference to enable acoustic coupling with hearing aids.

· T-Ratings: Rating for inductive coupling with hearing aids in telecoil mode.

This device complies with the FCC HAC requirements has also been tested E-Field, H-Field and T-Coil,

the worst test result of M rating is M4, the T rating is T3.

M-Ratings: Phones rated M3 or M4 meet FCC requirements and are likely to generate less interference

to hearing devices than phones that are not rated. M4 is the better/higher of the two ratings.

Your device is rated M4.

T-Ratings: Phones rated T3 or T4 meet FCC requirements and are likely to be more usable with a

hearing aid's telecoil than phones that are not rated. T4 is the better/higher of the two ratings.

Your device is rated T3.