LINKSYS WMP54GSV11 Users Manual

Wireless-G PCI Adapter with SpeedBooster

7. The Setup Wizard will ask you to review your settings before it starts to copy files. Click the Next button to
save these settings, or click the Back button to change any settings.

8. For Windows 2000 users, a screen stating that a digital signature was not found may appear. This software

has been tested and found to work properly with Windows 2000. Click the Yes button to continue installation.

Figure 3-13: The Check Settings Screen

Chapter 3: Software Installation and Configuration

Figure 3-14: The Windows Digital Signature Screen

13

Wireless-G PCI Adapter with SpeedBooster

9. After the files have been successfully copied, the Congratulations screen will appear. Click the Exit button.

Now that the software installation is complete, proceed to Chapter 4: Connecting the Wireless-G PCI Adapter.

Figure 3-15: The Congratulations Screen

Chapter 3: Software Installation and Configuration

14

Wireless-G PCI Adapter with SpeedBooster

Chapter 4: Connecting the PCI Adapter

1. Before connecting the PCI Adapter to your PC, turn off your desktop PC.

2. Open your PC case and locate an available PCI slot on the motherboard. Check with your computer
manufacturer for instructions.

3. Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are touching the slot's contacts. You may
have to apply a bit of pressure to slide the adapter all the way in. After the adapter is firmly in place, secure its
fastening tab to your PC's chassis with a mounting screw. Then, close your PC.

Figure 4-1: Your Computer’s PCI slot with Adapter installed

Chapter 4: Connecting the PCI Adapter

15