Linkskey LKS-SG5P User Manual

Page 1
Page 2
LKS-SG5P / LKS-SG8P
A
Introduction
LKS-SG5P / LKS-SG8P is 5/8-port 10/100/1000Mbps unmanaged Gigabit Ethernet Switch. The Switch provides 5/8 x 10/100/1000Mbps Auto-Negotiation RJ45 ports. All RJ45 ports support the Auto-MDI/MDI-X function. Every port can work as uplink port or common port. LKS-SG5P / LKS-SG8P provides a cost-effective, high performance, non-disruptive, smooth evolution into gigabit solutions. The Switch delivers superior performance with improving workgroup, network bandwidth, increasing network node, providing greater flexibility, installation convenience. It is the best choice for increasing your speed.
B
Features
Link-On and Cable Length Power Saving  Link-Down Power Saving  Energy-Efficient Ethernet (EEE), IEEE 802.3az  Complies with IEEE Half and Full-Duplex standards  Non-blocking wire-speed reception and transmission and
non-head-of-line-blocking forwarding
Supports IEEE802.3x full/half duplex flow control and back pressure  Auto-Negotiation RJ45 ports supporting Auto-MDI/MDI-X  Supports MAC address auto-learning and auto-aging  Compact design for desktop or wall mounting  Plug-and-play enabled for easy setup and configuration
Page 3
LKS-SG5P / LKS-SG8P
C
Hardware Installation
Connect the AC Power Adapter to the LKS-SG5P / LKS-SG8P, and then to a power outlet.
Connect an Ethernet network cable from the computer to an available Ethernet port on the LKS-SG5P /LKS-SG8P
2
Page 4
LKS-SG5P / LKS-SG8P
D
LED
Power LED GreenPower is on Not Illuminated:Power is off
Link/Act LED Green(Solid)indicate that the port is operating at 10 or 100Mbps. Orange(Solid)indicate that the port is operating at 1000Mbps.
Blinking : indicate that there is activity of data occurring at the port. Not illuminatedindicate that the link is not established at the port.
3
Page 5
LKS-SG5P / LKS-SG8P
Technical Specifications
Standards and Protocol
Transfer Method Store and Forward Number of Ports 5/8 x 10/100/1000Mbps Auto-Negotiation ports
IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3x
EthernetCat. 3, 4, 5 up to 100m
Network Media
Fast EthernetCat. 5, 5e up to 100m Gigabit EthernetCat. 5, 5e, 6 up to 100m LKS-SG5P2K
MAC Address
LKS-SG8P8K LKS-SG5P10G
Switching Capacity
LKS-SG8P16G 10Mbps14880pps
Frame Filtering and
100Mbps148800pps
Forward Rate
1000Mbps1488000pps 10/100MbpsGreen
LED
Link/Act
1000MbpsOrange
Indicator
Power
Dimension (L × W × H) 156 (L) X 106 (w) X 31(H) mm
Green
Operating Temperature:0°C ~40°C (32°~104°F) Storage Temperature:-40°C ~70°C (-40°~158°F)
Environment
Operating Humidity10%~90% RH, Non-condensing Storage Humidity:5%~90% RH, Non-condensing
4
Page 6
LKS-SG5P / LKS-SG8P
FCC Warning
This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user’s guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.
Reorient the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit in a different room
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
5
Loading...