Page 1
QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 545
DESCRIPTION
MICROPOWER STEP-UP SWITCHING REGULATOR IN SC-70
LT3460ESC6
Demonstration circuit 545 features the LT3460, step-up
DC/DC converter with 1.3MHz constant frequency in a SC70
package. There are two switching regulator circuits in
DC545. The 12V output boost converter (upper circuit) is designed to convert 5V input to 12V output at 70mA of load
current and the SEPIC converter (lower circuit) is designed to
convert 10V ~ 16V input to 12V at 50mA.
Table 1. Performance Summary
PARAMETER CONDITION VALUE
Input Voltage Boost Converter
Maximum Output Current Boost Converter
V
REG Boost Converter
OUT
Each circuit has a jumper for testing SHDN mode operation.
Placing the jumper (JP1 & JP2) to “Hi” enables LT3460 operation and placing the jumper to “Lo” disables the LT3460
and the converter will turn off.
Design files for this circuit board are available. Call the LTC
factory.
5V
SEPIC Converter
SEPIC Converter
SEPIC Converter
10V ~ 16V
70mA
50mA
≅
250mV
≅
200mV
QUICK START PROCEDURE
12V OUTPUT BOOST CONVERTER (UPPER CIRCUIT)
Refer to Figure 1 for proper measurement equipment setup and follow the procedure below:
1. Connect the input power supply (set at 5V) to
and
GND
pins of the
boost converter
.
2. Turn on the input power supply and observe the
output voltage, the output voltage should read
≅
12V
3. Turn on the load preset at
70mA
. The input cur-
Vin
4. Check the output ripple using the oscilloscope (refer to Figure 3). The output ripple should not be
greater than 60mV. Also check the switching frequency, it should be ≅1.3MHz.
rent should read around ≅200mA and the output
voltage should be 12.1V±0.25V.
1
Page 2
QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 545
MICROPOWER STEP-UP SWITCHING REGULATOR IN SC-70
12V OUTPUT SEPIC CONVERTER (LOWER CIRCUIT)
Refer to Figure 2 for proper measurement equipment setup and follow the procedure below:
1. Connect the input power supply (set at 10V) to the
Vin
and
GND
pins of the
2. Turn on the input power supply. The output voltages should read 0V.
3. Turn on the load box preset at 50mA. The input
current should read around ≅75mA and the output voltage should now read 12.1V±0.20V.
SEPIC converter
.
4. Slowly change the input power supply voltage
from 10V to 16V while observing the output voltage. The output should stay within 12.1V±0.20V.
5. Observe the input current at 16V, it should read
around 50mA.
6. Change the input power supply back to 10V and
check the output ripple using the oscilloscope (refer to Figure 3). The output ripple should not be
greater than 60mV. Also check the switching frequency, it should be ≅1.3MHz.
2
Page 3
QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 545
MICROPOWER STEP-UP SWITCHING REGULATOR IN SC-70
3
Page 4
QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 545
MICROPOWER STEP-UP SWITCHING REGULATOR IN SC-70
4
Page 5
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Analog Devices Inc.:
DC545A
Loading...