Linear HS9484SS User Manual

Housing

I NSTALLATION AND O PERATING I N STRUCTIONS

SUNSHIELDS

HS9480SS, HS9483SS
HS9484SS, HS9488SS

100 0014 001 AIG 10/02

Printed in U.S.A.

©2002 Aigis Mechtronics
1124 Louise Road, Winston-Salem, NC 27107-5450
Tel: [phone] Fax: [phone]

Data subject to change without notice

1DESCRIPTION

Provides protection from the direct rays of the sun and
promotes cooling to reduce internal housing temperatures.

HS9480SS: For use with HS9480 Series Housings
HS9483SS: For use with HS9483 Series Housings
HS9484SS: For use with HS9484 Series Housings
HS9488SS: For use with HS9488 Series Housings

Items Supplied:
HS9480SS, HS9483SS,
HS9484SS & HS9488SS

Sunshield (1)
Hardware Kit (315 3169 003)

Screws (2)
Washers (2)
Bushings (2)

2INSTALLATION

1. Place the sunshield over the housing and align the
screw, washer, and bushing with the threads in the
rear cap.

2. Insert the screws into the sunshield and screw them
into the rear cap (see

Figure 1).

3. Pivot the sunshield to cover the housing while lining
up the top screw with the hole in the housing's front
cap (see

Figure 2).

4. Sunshield can then be adjusted forward to obtain addi­tional front coverage.

5. Secure sunshield by tightening the top and the back
two screws.

Figure 1 Installing Sunshield

Figure 2 Installing Sunshield

Sunshield Assembly

Attach to Top

of Front Cap

Screw, Washer,

Bushing, (2 Each)

from Hardware Kit

Housing

Adjust shield to
desired position;
Secure with screw
as shown.