Page 1
Test Cable located inside dome
for field-of-view adjustment
while mounted.
2.95
74.9
2.50
63.5
Ø4.94
125.4
Ø6.24
158.6
Ceiling cut Ø5.75 in
(Ø146 mm) hole.
Recessed/In-Ceiling
8.025
ead,
conduit nut included.
Test Cable located inside dome
for field-of-view adjustment
while mounted.
6.45
163.8
Ø4.94
125.4
Ø6.24
158.6
2.95
74.9
2.50
63.5
Ø4.94
125.4
Ø6.24
158.6
Ceiling cut Ø5.75 in
(Ø146 mm) hole.
Recessed/In-Ceiling
Pendant/Pipe
4.430
6.055
153.8
4.430
112.5
Hole pattern permits mounting
of unit to a standard North
American double-outlet electrical
x using four screws, included.
8.025
3/4-14 NPSM thread,
conduit nut included.
Ceiling cut Ø5.75 in
(Ø146 mm) hole.
Now Part of
• HighResolution:540TVLines
• AvailableinColororWDRcameras
• Test Coax Connector Included for
QuickSetup
• 4.9-inchDome&6-inchHeight
• Recessed, Pendant Pipe or Wall
MountOptionsAvailable
• 3-AxisCameraBracket
Indoor Fixed 5-inch Dome Camera
112.5
3/4-14 NPSM thr
bo
3.265
82.9
D5 Series
The D5 Series indoor dome camera discreetly monitors your premises and protects your
business from unwanted events. Its compact design and versatile construction permit the
same housing to be wall mounted, pendant mounted from a pipe, or recessed into a ceiling.
Included with this package is a high resolution, 540 TVL camera and the choice of a Sony
CCD chipset for superb color performance or a Pixim® Wide Dynamic Range chipset for
installations with troublesome lighting issues.
The housing and trim ring are available in white or black.
Easy to install, the D5 Series packages require minimal setup time. Each dome comes with a
test coax loop which allows the installer to set the camera’s field of view and focus the image
on site after the unit has been mounted. A slotted inner liner masks the direction the camera
is pointing for added theft prevention. An additional support kit is available for installations
above drop ceilings with standard 2’x2’ tiles.
Page 2
o r d e r i n g g u i d e
To order the D5 package that meets your needs choose from the following options:
Choose your camera type, all packages come with a standard 2.8-11mm lens, add the type of mount that will
be used and the color. See the sample below to create the model number for ordering.
no te :
If you require assistance with your order or would like IP or UTP options, please call the factory for more
information.
ex am ple mode l num be r: d5CH211p-b
category camera type lens range mounting housing color
D5 CH 211 P -B
Dome
5-inch
CH - Color High
Resolution
WD - Wide
Dynamic Range
211 - 2.8-11mm lens
R - Recessed
P - Pendant/Pipe
W - Wall
-B - Black
-W - White
IP or UTP versions are available please call the factory for more information.
S p e C i f i C a t i o n S
C a m e r a S p e C i f i C a t i o n S
color high resolution wide dynamic range
D5CH211 D5WD211
Image Sensor
Signal System / Effective Pixels NTSC/ 786H x 494 V NTSC/ 720H x 540V
Horizontal Resolution 540TV Lines 540TV Lines
Power Max 1.8 W Max 4.5 W
Sensitivity (3200K)
usable picture, f/1.2 lens, 50 IRE
Signal to Noise More than 48dB (AGC off) More than 48dB
Electronic Shutter NTSC/ 1/60 ~ 100,000 Sec. _
White Balance / Auto
White Balance
1/3 Inch SONY Super DAD CCD 1/3 Inch DPS (Digital Pixel System)
0.3Lux/F 1.2 0.5Lux/F 1.2; 0.08Lux/F 1.2 (Slow Shutter)
(AWB/ATW/ATW XTEND/ATW DESAT/
Auto
MANUAL Selectable)
/ ATW 2000K to 11.000K
Privacy Masking function _ Up to 12 zones (optional)
EL/BLS Auto _
AGC _ Adjustable
Voltage Range
Dynamic Range _ 101dB Typical, 120dB maximum
24VAC ± 10% 24VAC ± 10%
Page 3
m e C H a n i C a l S p e C i f i C a t i o n S
Construction ABS plastic housing and inner liner in charcoal. Acrylic dome with light tint.
Finish Black and White
Housing
Weight 1.4 lb (0.63 kg)
Shipping Weight 2.41 lb (1.09 kg)
Cable Entry
Wiring harness includes Female BNC plug and 2 pin terminal block for 24 VAC.
(mating connector included)
e n v i r o n m e n t a l ( Rated for indoor use only.)
Operating +14 ºF to +122 ºF (-10 ºC to +50 ºC)
Temperature
Storage -4 ºF to +122 ºF (-20 ºC to +50 ºC)
Humidity 0% to 90% relative, noncondensing.
e l e C t r o m a g n e t i C C o m p a t i b i l i t y
Electromagnetic
Compatibility
EMC Designed to meet FCC Class A.
Safety Designed to meet CE, UL
a C C e S S o r i e S
Model Number(s) Description
D5AMT-W (WhiTe)
D5AMT-B (BlAck)
Mounting
D5Mk Mounting kit with support rails for suspended ceiling applications.
D5R-W (WhiTe)
Empty
Domes
D5R-B (BlAck)
D5P-W (WhiTe)
D5P-B (BlAck)
Wall mount for pendant version models.
Dummy Recessed Dome
Dummy Pendant Dome
Page 4
d 5 S e r i e S m o u n t i n g v e r S i o n S - d i m e n S i o n a l o u t l i n e S
Threaded conduit with
two conduit nuts. Size
3/4-inch or PG-21,
supplied by customer.
6.45
163.8
Test Cable located inside dome
for field-of-view adjustment
while mounted.
2.50
63.5
Ø4.94
125.4
Ø6.24
158.6
Pendant/Pipe
4.430
112.5
1.805
45.8
2.95
74.9
Hole pattern permits mounting
of unit to a standard North
American double-outlet electrical
box using four screws, included.
6.055
3.265
82.9
(4x) Ø0.180
4.6
153.8
4.430
112.5
Pendant/Wall
Ø4.94
125.4
Ø6.24
158.6
Recessed/In-Ceiling
3/4-14 NPSM thread,
conduit nut included.
8.025
203.8
8.775
222.9
Ceiling cut Ø5.75 in
(Ø146 mm) hole.
in
mm
Now Part of
1950 Camino Vida Roble, Suite 150
Carlsbad, CA 92008
Tel: 760.438.7000 800.421.1587
www.aigismech.com • www.linearcorp.com
231471 ACopyright © 2011 Linear LLC
Loading...