Linear CCM-2A User Manual

CCM-2A

PRODUCT DESCRIPTION

Linear’s Model CCM-2A (P/N ACP00936A) CCTV camera can be installed inside the

1. REMOVE THE COVER PLATE

RE-2 Residential Telephone Entry System. The camera provides a video signal for
viewing the area in front of the entry system.

Color
Camera

The camera is continuously powered by the RE-2. Focus has been factory adjusted to
a range of three to four feet. No adjustment is needed.

The CAMERA connector is used to connect the camera to the RE-2. The 3-conductor

REMOVE THE FOUR
SECURITY SCREWS
TO OPEN THE CASE

cable routes power to, and video from the camera.

Module

The RE-2 provides a video jack for connection to a video cable with a Type “BNC”
connector. Up to 400 feet of 75-ohm RG-59 video cable can be used. Longer cable
runs may require the use of a video amplifi er.

Installation Instructions

NOTE: If camera is being installed on an existing installation, system power
should be off prior to installing the camera.

USA & Canada [phone] & [phone]

[phone] - Toll Free FAX [phone]

www.linearcorp.com

2. PREPARE TO MOUNT THE CAMERA 3. REMOVE THE LENS CAP 4. INSTALL THE CAMERA

REMOVE THE SIX CIRCUIT
BOARD RETAINING SCREWS
AND FLIP THE CIRCUIT BOARD UP

REMOVE THE TWO RETAINING
SCREWS AND BRACKETS

REMOVE THE LENS CAP
FROM THE CAMERA LENS

CAMERA
MOUNTING
AREA

REMOVE THE
BLACK DOT
ON CAMERA
GASKET

PLASTIC
CAMERA
GASKET

5. CONNECT THE CAMERA AND VIDEO CABLE 6. TEST CAMERA LINEAR LIMITED WARRANTY

This Linear product is warranted against defects in material and workmanship for twenty four
(24) months. The Warranty Expiration Date is labeled on the product. This warranty extends
only to wholesale customers who buy direct from Linear or through Linear’s normal distribution
channels. Linear does not warrant this product to consumers. Consumers should inquire from
their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or

liabilities on the part of Linear Corporation for consequential damages arising out of or in
connection with use or performance of this product or other indirect damages with respect
to loss of property, revenue, or profi t, or cost of removal, installation, or reinstallation.

All implied warranties, including implied warranties for merchantability and implied warranties
for fi tness, are valid only until Warranty Expiration Date as labeled on the product. This Linear

Corporation Warranty is in lieu of all other warranties express or implied.

All products returned for warranty service require a Return Product Authorization Number (RPA#).
Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.

FCC NOTICE: This device complies with FCC Rules Part 15. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.

Copyright © 2009 Linear LLC 229333 A

CONNECT THE CAMERA'S
CABLE TO THE RE-2'S
CAMERA CONNECTOR

CAMERA

CONNECTOR

VIDEO

OUTPUT

CONNECTOR

CONNECT THE VIDEO CABLE FROM
THE MONITOR OR MODULATOR TO
THE RE-2'S VIDEO OUTPUT CONNECTOR

APPLY POWER TO THE ACCESS SYSTEM
THEN VIEW THE VIDEO MONITOR TO TEST
THE VIDEO OUTPUT FROM THE CAMERA

SECURE THE CAMERA
WITH THE TWO RETAINING
BRACKETS AND SCREWS