Linear AUJ3311, AUJ3321, AUJ3323, AUJ3343, AUJ5011 Specsheet

...

Commercial Door Operators

AUJ SERIES

Extended-Duty Jackshaft Commercial Door Operator

Extended-duty jackshaft garage door operator for vertical and high lift sectional doors.

Product No. See table below

DOOR TYPE

Fiberglass

Steel-24 Ga. Steel-22 Ga. Aluminum

Wood Steel-20 Ga. Steel-24 Ga. insulated

Steel-16 Ga. Steel-20 Ga. insulated

Steel-16 Ga. insulated

Operator size to use ➜

Equipped with

Floor Level Disconnect

MAXIMUM

DOOR AREA

(SQ. FEET)

330 420

310 375

280 340

195 275

145 225

1/3 HP 1/2 HP

RATINGS

• Maximum duty cycle: 35 cycles per hour, 100+ cycles per day

• Maximum door height: 24 feet

• Shipping weight: 90 lbs.

FEATURES

• Solid state control circuit

• Constant pressure required to close if no

entrapment devices are installed

• All Steel frame

• Adjustable friction clutch

• 3/4” Shafting and 1” Jackshaft

• Pillow block bearings on output shaft

• Floor level disconnect

• #41 Chain and Sprocket, 1/3 & 1/2 HP

• Solenoid brake standard

• Motor overload protection

• Wired to accept reversing devices

• Internally adjustable limit switches

• High starting torque, continuous duty motor

• 24-Volt control circuit with OPEN, CLOSE, and STOP 3-button station

• OPEN button (and single button) will automatically override down travel and reverse door to the full open position

• External terminals for single button (residential type) radio control

MODEL HP

AUJ3311 AUJ3321 230V 1P AUJ3323 230V 3P AUJ3343 460V 3P AUJ5011 AUJ5021 230V 1P AUJ5023 230V 3P AUJ5043 460V 3P

www.linearcorp.com Speciﬁ cations subject to change without notice800.421.1587

VOLTAGE &

PHASE

115V 1P

1/3

115V 1P

1/2

FACTORY OPTIONS

WARRANTY

• Linear photo beam kit: P/N HAE00056

• MVP-MR 3-channel open-close-stop modular receiver (installed): P/N 2650-159

• 2 years

Solid State Control

AUJ Series

JACKSHAFT OPERATOR WITH FLOOR

DISCONNECT

CUSTOMER PROJECT ARCHITECT/ENGINEER CONTRACTOR DRAWING NUMBER DATE SHEET OF

ORDERING INFORMATION:

SUPPLY __________ LINEAR OPERATOR(S) MODEL AU J __ __ __ __ S _________________________

WITH A MOTOR RATING OF __________HP, __________VOLTS, _____PHASE, _____HERTZ

FOR A __________ WIDE X __________ HIGH DOOR(S) WITH ______________________________________

SUPPLY _______ OPEN-CLOSE-STOP CONTROL STATION(S) IN NEMA _______ ENCLOSURE PER OPERATOR

______________ DRIVE SPROCKET ______________ DOOR SPROCKET

AUXILIARY AND OPTIONAL EQUIPMENT AS SPECIFIED BELOW OR ON ATTACHED SHEET:

ARCHITECTURAL SPECIFICATIONS (FLOOR DISCONNECT):

Electric door operator(s) shall be Solid State Control Model AUJ of the jackshaft type, manufactured by Linear LLC and Underwriters Laboratory (UL) listed. Horsepower, voltage and phase will be as required to properly operate the door. Operators will be equipped with two-stage speed reduction (V-belt primary and roller chain and sprocket secondary) and an adjustable slip clutch. A floor level disconnect device will be provided for mechanical disengagement to allow for manual door operation. The operator will be equipped with an integral limit system that provides accurate settings to control the open and close positions of the door and will not be affected by manual door operation or motor removal. The motor and operator will be protected against overload by a thermal protector and will be equipped with a solenoid operated brake with internal expanding 360 degree brake shoe. The operator will have a 24VAC secondary solid state control circuit with advanced switch selectable features, motor load delivered via high amperage, inductive load rated relays. The operator will have provisions for connecting open-close

-stop pushbutton stations, radio controls, and external obstruction sensing (reversing) systems. Operator will drive the door at a speed of approximately 11 inches per second.

NOTES: REFER TO PRODUCT DATA SHEET FOR GENERAL INFORMATION REFER TO DRAWING____________FOR WIRING DIAGRAM

LINEAR LLC Phone 800-421-1587 1950 Camino Vida Roble Ste. 150 Fax 800-468-1340 Carlsbad, CA 92008 Website www.linearcorp.com