Lindy 70570 User Manual

Gigabit Lan

+ USB2.0 PCI Host

User Manual

English

LINDY No. 70570

www.LINDY.com

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (November 2004)

1. Introduction

This PCI Host Adapter is a PCI controller board which can upgrade your desktop

computer to have Gigabit Ethernet (1000Mbps, 100 Mbps, 10 Mbps) and three USB2.0 /

USB1.1 ports.

The board supports a 32-bit 33 MHz PCI bus revision 2.2, USB transfer rate of 1.5Mb/s,

12Mb/s, 480Mb/s and Gigabit Ethernet 10/100/1000Base-T.

This Low Profile Form factor can support Low profile PCI and regular PCI both.

It comes with drivers for Windows.

1.1. Features

1.1.1. PCI Interface

Compliant with PCI Specification, revision 2.2.

32 bit, 33MHz fully compliant PCI host interface.

Integrated PCI DMA engines.

1.1.2. 1000Base-T Gigabit Ethernet

o Fully compliant with IEEE 802.3 (10Base-T Ethernet), IEEE 802.3u (100Base-TX

Fast Ethernet), IEEE 802.3z (1000Base-T Gigabit Ethernet)

o Supports Ethernet 10Mbps (half-duplex), Ethernet 20Mbps (full-duplex), Fast

Ethernet 100Mbps (half-duplex), Fast Ethernet 200Mbps (full-duplex), Gigabit

1000Mbps (full-duplex) and Gigabit 2000Mbps (full-duplex)

o RJ-45 Port offer high speed transmission over CAT 5 UTP cable

o Green LED indicator for 10/100/1000 Link

o Red LED indicator for ACT (Tx / Rx)

o Auto-Negotiation with Next page capability

o Supports pair swap/polarity/skew correction

o Crossover Detection & Auto-Correction

- 2 -

o Wake-on-LAN and remote wake-up support

o Microsoft® NDIS5 Checksum Offload (IP, TCP, UDP) and largesend offload support

o Supports Full Duplex flow control (IEEE 802.3x)

o Supports IEEE 802.1Q VLAN tagging

o 8K Transmit FIFO and 64K Receive FIFO support

o Supports power down/link down power saving

1.1.3. USB Interface

Provides three USB2.0 / USB1.1 ports (2 External + 1 Internal).

Compliant with Universal Serial Bus Specification Revision 2.0 (Data Rate

1.5/12/480 Mbps).

Compliant with Open Host Controller Interface Specification for USB Rev 1.0a.

Compliant with Enhanced Host Controller Interface Specification for USB Rev

0.95, All USB ports can handle high-speed (480 Mbps), full-speed (12 Mbps),

and low-speed (1.5 Mbps) transaction.

1.2. Package Contents

Gigabit LAN + USB 2.0 PCI Host

This User’s Manual

Low Profile PCI Bracket

Driver CD

2. Software Installation

2.1. Windows 2000 installation

1. Power up the system, and insert the Driver CD into your CD-ROM/DVD.

(Note: Do not install combo card before installing USB drivers in windows)

2. Browse the Driver CD, and points specify a location, example E:\USB2.0

Host\NEC\Win2K_XP\U2v2_1_4.exe

3. Double click on the “U2v2_1_4” icon, the USB 2.0 Driver V2.1.4 setup dialog

Will appear, when setup has finished, select “NO, I will restart my computer”. Click on

“close” button to exit the wizard, and power off the system.

4. Insert Combo Card into an available PCI slot, and power up the system.

- 3 -