Page 1
Manual
English
LINDY No. 70406, 70407, 70408 & 70409
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (Jan 2009)
www.lindy.com
Page 2
Page 3
User Manual
70408 - Digital to Analogue Audio Convertor
Introduction
Thank you for purchasing the LINDY Digital to analogue audio convertor. This convertor allows
you to input digital audio through a coaxial or optical port and output analogue audio through
left and right phono ports. A switch on the side of the unit determines which digital input is
active
Specifications
• Input ports: 1 x TOSLink (Optical Fibre) & 1 x Coaxial
• Output ports: 2 x Phono (Left & Right)
• Integrated digital interpolator filter and Digital to Analogue Converter (DAC)
• Supports uncompressed digital stereo audio input
• Power Supply: 5VDC 0.5A
• Dimensions: (WxDxH) 46 x 46 x 23.5mm
• Weight: 30g
• Housing: Plastic
• Colour: White
Operation
1. Optical/Coaxial switch: The switch determines which input is active
2. Power: Plug 5VDC PSU (included) into the unit and connect to a wall outlet
1. Optical/Coaxial input: Connect your Optical/Coaxial audio equipment
2. L/R output: Connect to your analogue audio device input port
Side View
Front Panel Rear Panel
Page 4
User Manual
70409 - Analogue to Digital Audio Convertor
Introduction
Thank you for purchasing the LINDY analogue to digital audio convertor. This convertor allows
you to input analogue audio through left and right phono ports and output digital audio through
Coaxial/optical ports. A switch on the side of the unit determines which digital input is active.
The output digital audio signal is a 2-channel uncompressed LPCM (Linear Pulse Code
Modulation) with a sampling rate at 48 KHz. Both Optical Fibre and Coaxial cables can be
connected at the same time and can run up to 5 meters while still provide reliable and lossless
audio signal transmission.
Specifications
• Input ports: 2 x Phono (Left & Right)
• Output ports: 1 x TOSLink (Optical Fibre) & 1 x Coaxial
• Supports uncompressed 2-channel LPCM (Linear Pulse Code Modulation) digital audio
signal output
• Supports output sampling rate at 48 KHz
• Power Supply: 5VDC 0.5A
• Dimensions: (WxDxH) 46 x 46 x 23.5mm
• Weight: 30g
• Housing: Plastic
• Colour: White
Operation
1. Power: Plug 5VDC PSU (included) into the unit and connect to a wall outlet
1. Phono input: Connect your phono audio equipment
2. Coaxial/optical output: Connect to your digital audio device input port
Side View
Front Panel Rear Panel
Page 5
User Manual
70406 – 2 Port Optical Audio Switch
Introduction
Thank you for purchasing the LINDY 2 port audio switch. This audio switch allows you to have
two digital optical fibre inputs and one digital optical fibre output. Each connected fibre cable
can run up to 5m while still providing a reliable and lossless audio transmission.
Specifications
• Input ports: 2 x TOSLink (Optical Fibre)
• Output port: 1 x TOSLink (Optical Fibre)
• Supports S/PDIF standard of digital audio transmission
• Supports uncompressed 2-channel LPCM (Linear Pulse Code Modulation) digital audio
signal output
• Supports compressed 2-channel and multi-channel Dolby and DTS audio signal
• Power Supply: 5VDC 0.5A
• Dimensions: (WxDxH) 46 x 46 x 23.5mm
• Weight: 22g
• Housing: Plastic
• Colour: White
Operation
1. Selection: Use this mini switch to select from 2 input ports A or B
2. Power: Plug 5VDC PSU (included) into the unit and connect to a wall outlet
1. Optical input: Connect your optical audio equipment such as DVD player or amp
2. Optical output: Connect to your digital audio device input port
Side View
Front Panel Rear Panel
Page 6
User Manual
70407 – 2 Port Optical Audio Splitter
Introduction
Thank you for purchasing the LINDY 2 port audio splitter. This audio splitter allows you to have
one optical fibre audio inputs and distribute it to two optical fibre audio outputs. Each
connected fibre cable can run up to 5m while still providing a reliable and lossless audio
transmission.
Specifications
• Input ports: 1 x TOSLink (Optical Fibre)
• Output ports: 2 x TOSLink (Optical Fibre)
• Supports S/PDIF standard of digital audio transmission
• Supports uncompressed 2-channel LPCM (Linear Pulse Code Modulation) digital audio
signal output
• Supports compressed 2-channel and multi-channel Dolby and DTS audio signal
• Power Supply: 5VDC 0.5A
• Dimensions: (WxDxH) 46 x 46 x 23.5mm
• Weight: 22g
• Housing: Plastic
• Colour: White
Operation
1. Power: Plug 5VDC PSU (included) into the unit and connect to a wall outlet
1. Optical input: Connect your optical audio equipment such as DVD player or amp
2. Optical output: Connect to your digital audio devices input ports
Side View
Front Panel Rear Panel
Page 7
CE/FCC/Recycling Information
CE Certification
This equipment complies with the requirements relating to electromagnetic compatibility, EN55022/EN55024 class B for
IEC/EN61000-4-2/3 the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of
the Member States relating to electromagnetic compatibility.
FCC Certification
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced technician for help
You are cautioned that changes or modification not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
WEEE (Waste of Electrical and Electronic Equipment),
Recycling of Electronic Products
United Kingdom
In 2006 the European Union introduced regulations (WEEE) for the collection and recycling of all waste electrical and electronic
equipment. It is no longer allowable to simply throw away electrical and electronic equipment. Instead, these products must
enter the recycling process.
Each individual EU member state has implemented the WEEE regulations into national law in slightly different ways. Please
follow your national law when you want to dispose of any electrical or electronic products. More details can be obtained from
your national WEEE recycling agency.
Germany
Die Europäische Union hat mit der WEEE Direktive umfassende Regelungen für die Verschrottung und das Recycling von
Elektro- und Elektronikprodukten geschaffen. Diese wurden von der Bundesregierung im Elektro- und Elektronikgerätegesetz –
ElektroG in deutsches Recht umgesetzt. Dieses Gesetz verbietet vom 24.März 2006 an das Entsorgen von entsprechenden,
auch alten, Elektro- und Elektronikgeräten über die Hausmülltonne! Diese Geräte müssen den lokalen Sammelsystemen bzw.
örtlichen Sammelstellen zugeführt werden! Dort werden sie kostenlos entgegen genommen. Die Kosten für den weiteren
Recyclingprozess übernimmt die Gesamtheit der Gerätehersteller.
France
En 2006, l'union Européenne a introduit la nouvelle réglementation (DEEE) pour le recyclage de tout équipement électrique et
électronique.
Chaque Etat membre de l’ Union Européenne a mis en application la nouvelle réglementation DEEE de manières légèrement
différentes. Veuillez suivre le décret d’application correspondant à l’élimination des déchets électriques ou électroniques de
votre pays.
Italy
Nel 2006 l’unione europea ha introdotto regolamentazioni (WEEE) per la raccolta e il riciclo di apparecchi elettrici ed elettronici.
Non è più consentito semplicemente gettare queste apparecchiature, devono essere riciclate. Ogni stato membro dell’ EU ha
tramutato le direttive WEEE in leggi statali in varie misure. Fare riferimento alle leggi del proprio Stato quando si dispone di un
apparecchio elettrico o elettronico.
Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio del proprio Stato.
1st Edition January 2009
www.lindy.com
Loading...