Lindy 51103 User Manual

PCMCIA/CardBus

Adapter Card

User Manual English

LINDY No. 51103

www.lindy.com

For Home and Office Use
Tested to Comply with FCC Standards

Hardware Installation

Important: Before beginning the installation we recommend you

use an anti-static wrist strap to prevent possible damage to the
sensitive internal components in your computer.

The card must be installed into a 32 Bit PCI expansion s lot in a
PC.

For standard desktop/tower PCs
the correct back plate is already
installed. For low profile PCs you
should install the low profile back
plate:

1. Power down your computer and unplug from the mains.

2. Remove the case cover.

3. Locate an available 32 Bit PCI slot.

4. Remove the slot blanking plate and retain the screw.

5. Carefully insert the card into the PCI slot.

6. Secure the card using the retained screw.

7. Replace the case covers, plug the system back into the

8. The drivers for the card will be automatically installed by the

Back plate is secured
by these two screws.

mains and switch on.
operating system.*

* Windows 98 users may be prompted to insert their
Windows CD.

Introduction

Thank you for purchasing the LINDY PCMCIA/CardBus Adapter.
With this “Plug & Play” 32 Bit PCI card you can upgrade your
desktop PC to support Notebook style PCMCIA/CardBus cards.

The card features two independent PC Card sockets which both
support Type I, II & III PC Cards. This allows you to mix and
match 5V/3.3V 16 Bit PCMCIA and 3.3V CardBus Cards. For
maximum versatility, the card features both standard and low
profile back plates.

Features

 32 Bit/33MHz fully compliant PCI-host interface
 Two independent PC Card sockets, compliant with the PC

 Supports Type I, Type II and Type III PC Cards
 Can be used with 5V/3.3V 16 Bit PCMCIA & 3.3V CardBus

 Supports hot-plugging and removal of cards
 Supports flash media and smart card PC Card adapters
 Texas Instruments chipset
 “Plug & Play” - no special software to install
 Compatible with Windows 98/ME/2000/XP

Card standard 7.1

Cards

Package Contents

 PCMCIA/CardBus Adapter Card
 Standard and Low Profile back plates
 This manual

Verifying the installation

To verify correct installation, start Windows Device Manager.
For example, in XP click:

Start >Control Panel > System > Hardware >Device Manager

You should see an entry similar to this:

www.lindy.com

2nd Edition November 2005