- 2 -
USB 3.0 5Gbps Host Adapter (NEC chipset)
1. Introduction
USB 3.0 SuperSpeed 5Gbps Host Adapter to support all kind of 1.5Mbps, 12Mbps,
480Mbps and 5Gbps USB Devices!
1.1. Features
o
Compliant with Universal Serial Bus 3.0 Specification Revision 1.0
o
Compliant with Intel eXtensible Host Controller Interface (xHCI) Specification
0.95
o
All USB ports can handle SuperSpeed (5 Gbps), HighSpeed (480 Mbps),
FullSpeed (12 Mbps), and LowSpeed (1.5 Mbps) transaction
o
Supports any USB3.0, USB2.0 and USB1.1 devices
o
Compliant with PCI Express Specification 2.0 or PCI Specification 3.0
o
64bit and 32bit Windows 7, Vista, XP drivers support
o
Chipset : NEC
1.2. DC Power Jack Spec (Optional in ExpressCard)
o
Power Input : 5V / 2A
o
Polarity: Center --- Positive Power (V+), Outer --- Power Return (V-)
o
Power Plug: 3.5mm * 1.3mm * 9mm
1.3. 4 Pin Wafer Power Connector (optional in mini PCIe)
1.4. 20Pin USB3 Internal Connector (optional in internal PCBA)
2. Windows 7/Vista/XP Driver Installation
1. Insert various USB 3.0 host adapter into an available PCIe or PCI or mini PCIe or
ExpressCard slot.
2. If PCIe card, better to connect power cable from PC Power supply to PCIe
card power connector, or you may see message “Power Surge on Hub
Port” and no sufficient 5V bus power in USB ports.
3. Windows will display the 'Found New Hardware Wizard'.
4. Skip the driver installation
5. Run installer setup.exe on Driver CD E:\ USB3.0 Host\NEC to have the latest
driver for 32bit /64bit Windows.