Lindy 43188 User manual

For Home and Office Use!

USB 3.1 Gigabit Ethernet Adapter

User Manual English
Benutzerhandbuch Deutsch
Manuel Utilisateur Français
Manuale d’uso Italiano

No. 43188

www.lindy.com

Tested to Comply with
FCC Standards

© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (December 2015)

User Manual English

Introduction

Thank you for purchasing the LINDY USB 3.1 Gigabit Ethernet Adapter, which allows you to connect
your computer to a 10/100/1000Mbps network through an existing USB port. Due to the products USB

3.1 Gen 1 specification, this adapter ensures true 10/100/1000Mbps network speed.

Package Contents

• USB 3.1 Gigabit Ethernet Adapter

• Driver CD

• This Manual

Specification

• USB 3.1 Gen 1 / USB 3.0 up to 5Gbps, USB 2.0 / 1.1 compliant

• Network standards: IEEE 802.3/802.3u/802.3ab (10Base-T/100Base-T/1000Base-T),

IEEE802.3az (Energy Efficient Ethernet)

• Data Transfer Rates: Ethernet 10Mbps, Fast Ethernet 100Mbps and Gigabit Ethernet 1000Mbps
(Half/Full Duplex)

• Interfaces: 1x USB 3.0 A male, 1x RJ45 female

• Compatible with USB equipped computers (Windows/Mac/Linux)

Product Overview

1d4576ufju

jgjkafuigiuifgjkjhklsjhlskjthoiptjhlfjkltohkklsk

1. The red LED is lit when connected with the USB 3.1/3.0 speeds and off when connected to a USB

2.0 port. It also flashes during USB data transfer.

2. The green LED will flash when data transfer is in progress.

3. The blue LED is lit when a live network cable is connected.

User Manual English

Installation*

DO NOT connect the Ethernet Adapter to the computer before completing the driver installation.

Insert the Driver CD into your disk drive. Locate and double click <Setup.exe> to launch the setup
procedure. Complete the installation process as guided.
Alternatively, you can download the driver from www.lindy.com.

Verifying the driver

Windows:
Connect the USB to Ethernet adapter to the Machine.
Open the Device Manager in the Windows Control Panel.
In the Network adapters group, an item named “ASIX….Ethernet Adapter” should be listed.

Mac OS X:
Connect the USB to Ethernet adapter to the Mac.
Click the System Preferences -> Network -> USB Gigabit Ethernet device, which should be active and
on line.

Note: If a question or exclamation mark appears, then driver is not properly installed. Please delete the
item then, unplug the adapter and repeat the installation.

Connection

Connect the adapter to an available network when the installation procedure is completed. To do this,
connect an Ethernet cable to the Ethernet port of the adapter and then connect the other end of the
Ethernet cable to an available network hub, switch or router.

* The description of the driver installation shown here is an example. The actual strings and screen shots
may vary slightly on each operating system

.