to
and a host
USB Type A connector (host
built in
(UTP or
Full Speed data
At a
cable,
) can be
to connect more
When the USB devices you want to connect to the remote
unit require more then 250mA in total (find this information in
the Device Manager tab when you connect the devices to
DC
,
be connected to the remote unit
the USB bus. It does
only
with the USB bus. It is capable of
maximum distance of 5m by one USB
ers. Please
otherwise the USB bus may not
connected to an
such as
you must connect
wird verwendet um
auf bis zu
weitern. Er besteht aus einer lokalen Einheit (mit
Kabel mit Typ A Stecker, Computerseite) und einer
1.1 4 Port
Netzwerkkabel bis zu
Der Extender unterstützt den USB 1.1 / 2.0 Full Speed Mode
s zu 50m. Bei einer
maximalen Netzwerkkabellänge von 40m kann an jeden Port
weiterer USB Hub
Wenn die anzuschließenden USB Geräte zusammen einen
s 250mA haben (diese Info finden Sie
im Windows Device Manager angezeigt), muss in jedem Fall
Netzteil (5VDC, geregelt, z.B. LINDY Art.Nr.
39291) angeschlossen werden um einen fehlerfreien Betrieb
und
erfüllt nicht alle USB Spezifikationen. Er wird nur als USB Hub
male
mehrere dieser Extender hintereinander verwendet werden.
Alle oben genannten Punkte müssen durch den Nutzer selbst
beachtet werden. Bei Überschreitung der Angaben kann das
USB High Current Devices wie
das optionale
(z.B. LINDY Art.Nr. 39291, nicht im Lieferumfang
Dieser USB Extender unterstützt nicht das USB 50µA
USB Cat.5 Extender with Hub
User Manual English
Benutzerhandbuch Deutsch
Manuel Utilisateur Fançais
Manuale d’uso Italiano
USB Extender
Local Unit
(Computer side, attach
to mainboard)
directly
LINDY No. 42802
For Home and Office Use
Tested to Comply with FCC Standards
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (FEB 2006)
www.LINDY.com
USB Extender
Remote Unit
with 4 Port Hub
(Device side)
English Manual
Introduction
The LINDY USB Cat.5 Extender with Hub can be used
extend the distance between USB devices
computer by up to 50m / 150 feet.
It consists of a local unit, with a
computer side), and a remote unit (device side) with a
USB 1.1 four port hub. Standard Cat.5 network cable
STP) of up to 50m in length (150 feet) is used to connect the
two units together.
The Extender supports USB 1.1 & 2.0
transfer (12Mbps) at distances of up to 50m (150 feet).
maximum length of 40m for the Cat.5 interconnect
ONE additional USB hub (with power supply
connected to each port of the remote unit,
than 4 USB devices.
your computer), an optional USB power supply (5V
regulated, e.g. LINDY No. 39290(UK), 39292(US)
39291(Schuko-IEC)) must
for proper operation of the USB devices.
Specifications
USB Interface: USB 1.1 type operation
Supports UTP/STP cable length up to 50m / 150 feet
Note: This unit works transparently to
not fully meet all USB Specifications and as such
registers as a USB hub
extending the USB
segment only. You cannot daisy-chain extend
consider these limitations,
function correctly! It should also be directly
exclusive (i.e. mainboard) USB port on your computer.
Please note: When using a high current USB device
a modem, camera etc. with this extender,
an optional power supply (not included)!
Technical Data
Operating Temperature: 0~40°C
Storage Temperature: -40~85°C
For indoor use only!
Please note: The USB Extender does not support the USB
50uA maximum Suspend Mode current limit.
Deutsches Benutzerhandbuch
Einführung
Der LINDY USB Cat.5 Extender with Hub
Distanzen zwischen Computer und USB Geräten
50m zu er
USBRemote-Einheit (Device-Seite) mit eingebautem USB
Hub. Zur Verbindung werden Standard50m Länge (Kategorie 5 oder höher) verwendet.
Datentransfer 12MBit/sec.) über bi
des USB Hub am Remote Unit EIN
angeschlossen werden um weitere USB Geräte anzuschließen.
höheren Strombedarf al
ein optionales USB-
sicher zu stellen.
Spezifikation
USB INTERFACE: Typ USB 1.1 Funktion
Kabellänge für Netzwerkkabel (UTP/STP Cat.5) bis 50m
Dieser USB Extender arbeitet im USB Bus transparent
im USB Bus angemeldet. Daher kann er auch die maxi
USB-Segmentlänge von 5m überschreiten! Es können nicht
Funktionieren nicht garantiert werden.
Achtung! Bei Anschluss von
USB-Modem, USB-Digicam etc. muss immer
USB-Netzteil
enthalten) verwendet werden!
Technische Daten
Zulässiger Temperaturbereich für Betrieb: 0~40°C
Zulässiger Temperaturbereich für Lagerung: -40~85°C
Nur zur Verwendung in geschlossenen Räumen
Hinweis:
Suspend-Mode Stromlimit.
Radio Frequency Energy, Certifications
peut être utilisé pour étendre la distance
Cela consiste en une unité locale avec connecteur USB Type
L’Extender supporte les transferts de données à 12 Mbits
jusqu’à 50m. Sur une longueur maximale de 40m, un second
pour bénéficier de plus de
connexions USB. Si les périphériques USB que vous
souhaitez connecter utilisent plus de 250mA au total, une
alimentation optionnelle est nécessaire (Art. 39291) et doit être
Ce boîtier travaille de façon transparente sur le bus USB.
Il sera reconnu en tant que hub USB dans le système. Vous
ne pourrez pas chaîner les Extenders et il est nécessaire de
Il permet d’étendre la longueur maximale de 5m de la norme
Si vous utilisez un périphérique
beaucoup de puissance, comme des modems,
etc…., vous devez obligatoirement utiliser l’alimentation
L’Extender USB ne supporte pas le mode de
permette di utilizzare
periferiche USB fino a 50 m di distanza dal computer.
Questo prodotto è composto da un’unità locale con un
connettore USB tipo A (per il computer) e da un’unità remota
B tipo A femmina (per la periferica) con
un Hub USB 1.1 4 porte integrato. Per connettere queste
due unità si utilizza un cavo di rete standard Cat. 5 (UTP o
L’Extender supporta le specifiche USB 1.1 e 2.0 con velocità
Hub addizionale con alimentatore
ad una distanza massima di 40m per connettere più di 4
Nel caso in cui le periferiche USB che si desidera collegare
vamente più di 250mA è necessario
Questa unità non risponde completamente a tutte le
errà riconosciuta dal Bus USB come
Hub USB. E’ possibile raggiungere una distanza massima di
50 m utilizzando un solo apparato, non è possibile collegare
L’utente deve tener conto di tutte le raccomandazioni
te; in caso contrario il BUS USB
potrebbe non funzionare correttamente. Questa periferica
deve essere connessa direttamente ad una porta USB del
Se utilizzato periferica USB ad alto assorbimento di
to Extender,
ricordatevi di collegare sempre un alimentatore aggiuntivo
l sistema di
Shielded cables must be used with this equipment to maintain
compliance with radio frequency energy emission regulations and
ensure a suitably high level of immunity to electromagnetic
disturbances.
FCC Warning
This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation
LINDY No. 42802
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition - FEB 2006
Manuel Utilisateur
Introduction
L’ USB EXTENDER
entre un ordinateur et un périphérique USB jusqu’à 50 mètres.
Manuale d’uso
Introduzione
Il Lindy USB EXTENDER con Hub
A (côté ordinateur) et une unité distante (côté périphérique)
avec un hub USB 1.1 4 ports intégré. Un câble Cat. 5 STP
con un connettore US
standard est utilisé pour connecter les deux boîtiers.
STP) lungo fino a 50 m.
hub pourra être interconnecté
di trasferimento dati di 12 mbps fino a 50m di distanza.
E’ possibile collegare un
connectée au boîtier distant.
periferiche USB.
Spécifications
INTERFACE USB: Type USB 1.1
Interconnexion par câble UTP/STP jusqu’à 50m
richiedano complessi
collegare un alimentatore USB addizionale, art 39291.
Specifiche:
INTERFACCIA USB: USB 1.1
Lunghezza cavo UTP/STP di interconnessione fino a 50m
les brancher directement sur un port USB de l’ordinateur !
Cet appareil ne répond pas à toutes les spécifications USB.
specifiche USB e non v
USB pour un segment.
più Extender in cascata.
Remarque Importante:
precedentemente descrit
consommant
optionnelle pour l’Extender !
Données Techniques
Température d’utilisation: 0~40°C
Température de stockage -40~85°C
Pour utilisation intérieure uniquement !
Remarque :
limitation d’énergie de 50µa.
PC.
N.B.:
corrente (Modem, Drive Esterni, ecc..) con ques
(non in dotazione)
Dati Tecnici
Temperatura di funzionamento: 0~40°C
Temperatura di conservazione: -40~85°C
Esclusivamente per uso interno
Attenzione: questo Extender non supporta i
sospensione automatica di corrente a 50uA
Loading...