Lindy 42801 User Manual

I

a

p

w

1

e

E

w

j

A

k

F

C

U

LINDY USB Extender

User Manual English
Benutzerhandbuch Deutsch
Manuel Utilisateur Fançais
Manuale d’ uso Italiano

USB Ext ender
Local Unit

(Computer side)

or Home and Office Use

Tested to Comply with FCC Standards

© LINDY ELEC TRO NICS LIMITED & LINDY-ELEKTRON IK GMBH - FIRST EDITION (Mar-2003)

at.5 extension

cable 5…50m

not incl uded

LINDY No. 42801

www.LINDY.com

SB Ext ender
Remote Uni t

(Device side)

English Manual

ntroduction

The LINDY USB EXTENDER can be used to extend the
distance between a USB device and a host computer by up
to 50m / 150 f eet . It consists of a local u n it with USB Type A
connector (host comput er side) and a rem ot e unit ( device
side with built i n USB type A female connector). St andar d
Category 5 Network cable (UTP or STP) up to 50m length
(150 feet) is used to connect the two units.
For cert

ossible to extend the distance e ve n further up to 100m. This

extended distance may not be guaranteed. In most cases
USB 1.1 Full Speed data transfer (

xtended distances but is guaranteed to work up to 50m (150

feet).

in USB Low Speed devices like USB mice it may be

ill depend very much on the device connected, as this

2Mbp s ) will not work ov er

Specification

USB INTERFACE: USB 1.1 type operation
Interconnect UTP/STP cable length up to 50m / 150 feet
Equivalent Hub Delay/Count: 20m / 60 feet 2 Hubs
30m / 100 feet 3 Hubs
50m / 150 feet 5 Hubs
Please note! The maximum number of hubs in any USB
connection from host t o device cannot be more than 5
including any USB Hubs or Active Extension cables or the
equivalent Hub rating of thi s USB EXTENDER!

Therefor e when using a 50m UTP/STP cable no extra

hubs or extension cables can be used between

computer and device!

Please note! When using a high current USB device such as
a modem, camera etc with the USB EXTENDER you must
connect the power supply supplied with the device!
Please note! The USB Extender does not support the USB
50uA maximum Suspend Mode current limit.

Technical Data

Supply Current Drawn: 20~40mA
Operating Temperature: 0~40°C
Storage Temperature -40~85°C

Caution!

This unit does not fully meet all USB Specificati ons and as
such does not register with the USB bus. It is capable of
extending the maximum dist ance of 5m imposed by USB by
one USB segment only. Please consider these limitations
otherwise the USB bus may not function correctly! It should
also be connected to an exclusive USB port on your
computer.

Deutsches Benutzerhandbuch

inführung

Der LINDY USB-EXTENDER wir d verwendet um Distanzen
zwischen Computer und USB Geräten auf bis zu 50m zu er-

eitern. Er besteht aus einer lokalen Einheit (mit USB-Kabel mit
Typ A Stecker, Computerseite) und einer Remote-Einheit
(Device-Seite mit eingebauter USB Typ A Buchse). Zur Ver­bindung werden Standard-Netzwerkkabel bis zu 50m Länge
(Kategorie 5 oder höher) verwendet.
Für einige Low Speed USB Geräte wie Mäuse können auch
Distanzen bis 100m überbrückt werden, LINDY übernimmt

edoch keinerlei Verantwortung für das Funkt ionieren bei
Distanzen oberhalb von 50m. USB 1.1 Full Speed Datentrans­fer mit 12Mbps wir d oberhalb von 50m höchstwahrscheinlich
nicht korrekt funkti onieren.

Spezifikation

USB INTERFACE: Typ USB 1.1 Funktion
Kabellänge für Netzwerkkabel (UTP/STP Cat.5) bis 50m
Äquivalenz-Hub-Signalverzögerung : 20m 2 Hubs
(Entspricht einer Anzahl von Hubs) 30m 3 Hubs
50m 5 Hubs
Achtung 1: Die Maximale Anzahl von Hubs in USB-Bussen
vom Comput er bis zum letzten Device darf 5 nich
überschreiten! Einschließlich anderer Hubs oder Aktivverlänge­rungen und der Äquivalenz-Hub­Distanz (siehe oben)! Bei Einsatz eines 50m Verbi ndungs-

kabel darf daher
USB Device verwendet werden!
Achtung 2: USB High Current Devices wie USB-Modem etc.
müssen immer mit eigenem Netzteil verwendet werden!
Achtung 3: Dieser USB Extender unterstützt nicht das USB

50µA Suspend-Mode Stromlimit.

ein weiterer Hub zwischen Computer und

nzahl dieses Extenders nach

Technische Daten

Typischer Stromverbrauch: 20~40mA
Zulässiger Temperaturbereich für Betrieb: 0~40°C
Zulässiger Temperaturbereich für Lagerung: -40~85°C

! WARNUNG !

Dieser USB Extender erfüllt nicht al le USB Spezifikati onen.
Daher kann er auch die maximale USB-Segmentlänge von 5m
überschreiten! Er registriert sich nicht i m USB Bus beim Host.
Alle oben genannten Punkte müssen durch den Nutzer selbst
beachtet werden. Bei Überschreitung der Angaben kann das
Funktionieren nicht garantiert werden. Bei Verwendung von
50m Verbindungskabel darf kein weiteres Device zwischen
Computer und Endgerät eingesetzt werden!

Radio Frequency Energy, Certifications

I

L

I

l

U

P

p

Q

ca s

Shielded cables must be used wi th th is equipment to maintain
compliance with radio frequency ene rgy emission regulations and
ensure a suitably high level of immunity to electromagnetic
disturbances.

FCC Warning

This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interfere nce in a residential installation. This
equipment ge nerates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communicatio n s. However, there is no gu arantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television receptio n, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:

! Reorient or relocate the receiving antenna
! Increase the sepa ration betwee n th e equipment and receive r
! Connect the equipment into an outlet on a circuit different from

that to w h ich the receiver is connected

! Consult the dealer or an experienced technician for help
You are cautioned tha t changes or modifications not ex pressly

approv ed by the party responsible for compliance could void y our
authority to operate the equipment.

This device complies with part 15 of the FCC Rules.
Operation is subject to the followi ng two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including
interference that may cause undesired operation

LINDY No. 42801

© LINDY ELECTRONICS LIMI TED & LINDY-ELEKTRONIK GMBH - First Edition - MAR 2003

Manuel Utilisateur

ntroduction

L’ USB EXTENDER peut être utilisé pour étendre la distance
entre un ordinateur et un périphérique USB jusqu’à 50 mètres.
Cela consiste en une unité locale avec connecteur USB Type
A (côté ordinateur) et une unité di st ante (côté périphérique)
avec connecteur USB type A femelle intégré. Un câble Cat. 5
STP standard est utilisé pour connecter les deux boîtiers.
Pour certains périphéri ques USB bas débit, i l est possible
d’étendre la longueur de connexion à 100m maximum.
Ceci n’est tout de même pas garanti.

Spécifications

INTERFACE USB: Ty p e USB 1.1
Interconnexion par cable UTP/STP jusqu’à 50m
Equivalent avec connexion de Hubs:
20m 2 Hubs
30m 3 Hubs
50m 5 Hubs
Remarque Importante 1:

e nombre maximum de hubs pour
une connexion ne doit pas dépasser 5 hubs ! Si vous utilisez
un câble de 50m UTP/STP vous n’aurez pas besoin de
connecter de hubs supplémentaires!
Remarque Importante 2: Si vous utilisez un périphérique
consomm ant beaucoup de puissance, comme des modems,
etc…., vous devez obligatoirement utiliser l’alimentation
fournie avec ce périphérique!
Remarque Importante 3: Cette extension USB ne supporte
pas le mode suspend 50µa.

Données Techniques

Consommation: 20~40mA
Température d’utilisation: 0~40°C
Température de stockage -40~85°C

! ATTENTION !

Cet appareil ne répond pas à toutes les spécifications USB.
Il permet d’étendre la longueur m aximale de 5m de la norme
USB pour un segment.
Il se peut que le port USB ne fonctionne pas correctement si
vous connectez plusieurs périphériques en supplément de
l’extension.

Manuale d’uso

ntroduzione

Il Lindy USB EXTENDER permette di uti l izzare periferiche
USB fino a 50 m di distanza da
composto da un unit à locale con un connettore USB tipo A

computer. Questo sistema è

(lato del computer Host) ed un’unità remota con connettore

SB tipo A femm i na ( lato periferica) . Per connettore questo
due unità si utilizza un cavo per reti locali standard Cat. 5
(UTP o STP) lungo fino a 50 m.

er alcune periferiche USB a bassa velocità come i mouse è
possibile raggiungere una distanza fino a 100m ma questa
caratteristic a on può essere garantita.

Specifiche:

INTERFACCIA USB: USB 1.1
Lunghezza cavo UTP/STP di interconnessione fino a 50m
Numero di Hub/Ritar do Equi valente: 20m -> 2 Hub
30m -> 3 Hub
50m -> 5 Hub

Raccomandazioni:
1: Il num ero massimo di Hub i n una connessione USB dal

PC alla periferica non può essere superiore a 5 inclusi
qualsiasi Hub USB, prolunga at tiva o il numero di Hub
equivalenti di questo USB Extender!
Di conseguenza usando un cavo UPT/STP da 50 non si

otranno util izzare altri Hub USB o prolunghe attive fra il PC
e la periferica.
2: Se utilizzato periferica USB ad alto assorbimento di
corrente (Modem, Drive Esterni, ecc..) con questo Extender
ricordatevi di collegare sempre l’alimentatore fornito in
dotazione
Caution 3: Questo extender non supporta il sistema di
sospensione automatica con limit e a 50uA.

Dati Tecnici

Corrente assorbita: 20~40mA
Temperature di funzionamento: 0~40°C
Temperature di conservazione -40~85°C

! ATTENZIONE !

uesta unità non rispetta completamente le specifiche USB

per cui esso può estendere oltre i 5m imposti dal l a specif i

olo un segmento USB. Non verrà inoltre registrato nel BUS
USB. L’utente deve tener conto di tutte le raccomandazioni
precedentemente descritte; in caso contrari o il BUS USB
potrebbe non funzionare correttamente. Questa periferica
dovrebbe essere connessa direttamente ad una porta USB