Lincoln Electric SP-200 User Manual
Specifications and Main Features
- Type: AC Line Single Phase and Constant Voltage Arc Welding Power Source and Wire Feeder Semi Automatic
- Model: IDEALARC® SP-200
- Output Rating: In rated output increments of a max 200 amps at 26 volts with a 60% duty cycle reserved on the 60 Hz model class.
- Input Voltage: Can function on a single phase or either of two or a three-phased input line.
- Wire Speed: Capable of adjusting wire speed between 50 to 400 inches per minute.
- Features:
- Display and Indicator: includes a Voltmeter which provides feedback such as output voltage.
- Coarse Arc Voltage Control features Patriot engineering offered with a 5 position selector switch.
- Fine Adjustment Meter: Arc Volt control: continuously adjustable controls takes over.
- Cut out switch (on/off function and overload protection): Wire Feed Circuit Breaker.
- Dimensions: These dimensions are not included in the text
- Weight: This specific weight is absent from the text
- Additional Footages:
- 15 feet work cable that is accompanied with wiring clamp.
- A drive roll sample packet for feeder electrode trim sizes of a particular.
- Wire rev stand.
- Input cable (length depends on voltage supply).
- Additional Basic Features( Optional) : Modification Kits, Time Delay Circuit Boxes, Solenoid Valves and many more.
Frequently Asked Questions
Q1: What is the category of power supply for the model IDEALARC® SP-200
A1: The IDEALARC® SP-200 is a power source that falls in the category of a single phase and constant voltage class.
Q2: Could you outline the maximum output that the SP-200 can manage?
A2: This item has an output rating of 200 Amperes at 26 volts and 60% duty cycle.
Q3: On this device, what wire speeds are adjustable?
A3: The cutter can be set to cut at an adjustable range of 50 to 400 inches per minute.
Q4: Are there any extra accessories that are included in the SP-200 package?
A4: Yup, 15 feet work cable with a work clamp, drive roll kit of specific diameter electrodes set and wire reel chair are also included.
Q5: Spool P-200. Can it weld aluminum?
A5: It Can, Aplications are using :- SP-200 with Aluminum electrodes but Commercial SP-200 Aluminum Conversion Kit has to be provided to the SP-200 first.
Q6: How do I get your recommendations on safety?
A6: Recommendations on your safety are found in the manual, inside the front cover, where this information is placed in detail.
Q7: The wire feed is rough or not feeding, what should I do?
A7: Check gun cable whether there is any kinking, wire blockage, rolling drive problems if correct rolls are not or tubes fitted or tightening to squeeze wheel pressured.
User Manual
Loading...