Lincoln Electric REDCO INSTABLEND 16900, REDCO INSTABLEND 16901, REDCO INSTABLEND 16902, REDCO INSTABLEND 16903, REDCO INSTABLEND 16904 Operating Manual

INSTALLATION & OPERATING

INSTRUCTIONS

for

REDCO® INSTABLEND™

MODEL 16900 SERIES

TO BE SERVICED ONLY BY AUTHORIZED PERSONS

Instablendopsman REV: 4/10/07

Part Number: 2810255

WARNING AND SAFETY INFORMATION

WARNING

!

!

TO AVOID ELECTRICAL SHOCK THAT CAN CAUSE SEVERE INJURY OR DEATH, ALWAYS UNPLUG
LIQUIDIZER / MIXER BEFORE PROCEEDING WITH ALL MAINTENANCE OR CLEANING PROCEDURES!

IN ORDER TO AVOID DAMAGE TO PEOPLE AND THE APPLIANCE, READ AND FOLLOW THE
MANUFACTURER’S INSTRUCTIONS FOR THE CLEANING OF THE LIQUIDIZER / MIXER.

LIMITED ONE (1) YEAR WARRANTY

Lincoln Foodservice Products, LLC (“Lincoln”) warrants, to the original purchaser for use in the United States of
America, that each new item of Redco Insta Blend, Insta Prep or Insta Juice manufactured by it (“Warranted
Product”) is free of defects in material and workmanship under normal use and conditions.

The exclusive remedy available under this Limited Warranty is that Lincoln will, free of charge, but at its option,
subject to, and in accordance with the terms and conditions of this Limited Warranty, repair or replace, for the
original purchaser for use in the United States of America, any Warranted Products or part thereof that proves to be
defective with the same or a similar item or part, it is returned to Lincoln in accordance with the procedure set out
on the warranty card.

This Limited Warranty applies only to original parts of Warranted Products sold for use in the United States of
America and does not apply to any Warranted Products located outside the United States of America, regardless of
where sold, or to any item or part thereof that has been subjected to accident, casualty, alteration, misuse, or abuse
or if the date of manufacture is altered or removed.

THE OBLIGATION OF LINCOLN IS LIMITED TO THE ABOVE AND, EXCEPT AS EXPRESSLY STATED
HEREIN, LINCOLN MAKES NO GUARANTEES OR WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING,
WITHOUT LIMITATION, WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO
WARRANTED PRODUCTS. LINCOLN SHALL NOT BE LIABLE FOR SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES OF ANY KIND, NO ONE IS AUTHORIZED TO MAKE ANY GUARANTEES OR
WARRANTIES, EXPRESSED OR IMPLIED, ON BEHALF OF LINCOLN.

SOME STATES DO NOT ALLOW LIMITATIONS OF IMPLIED WARRANTIES, OR THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTLY DAMAGES IN CONNECTION WITH THE SALE OF
CONSUMER PRODUCTS, CONSEQUENTLY, IF YOU ARE A CONSUMER, AS THAT TERM IS LEGALLY
DEFINED, THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.

TABLE OF CONTENTS

Limited Warranty……………………………………………………………………………………………………………….. 2
General Information / Specifications…………………………………………………………………………………………. 3
Operating Instructions………………………………………………………………………………………………………….. 4
Maintenance…………………………………………………………………………………………………………………..… 5
Shock Hazard / Warnings……………………………………………………………………………………………………… 6
Parts Lists with Diagrams……………………………………………………………………………………………………… 8
Schematics……………………………………………………………………………………………………………………. 12

InstaBlend - 16000 Series Ops Manual

2

MODELS

This manual describes the operation and maintenance of the 16900, 16901, 16902, 16903 and 16904 portable
liquidizers, mixers and liquidizer/mixers.

The model reference and its specifications are shown on the identification plate located on the front of the unit.

The InstaBlend has been designed and manufactured in accordance with the following standards:
Standards for machine safety: UL 1097, UL 763, UL 94
Standards for Hygiene and Food equipment materials: ANSI-NSF 8 and ANSI-NSF 51.

UTILITY SPECIFICATION

REDCO® INSTABLEND™

Specifications 16900 16901 16902 16903 16904

Liquidizer Arm Length 15” 21” 15” - 10.5”
Mixer Arm Length - - 15.5” 15.5” ­Total Length 29” 35” 27.5” 28” 21.5”
Electrical Supply 120V / 50Hz / 60Hz / 1 Phase
Constant Speed (RPM) 14000 15000 14500
Range (RPM) 1000-11000 1000-11000 14500
Weight 7.4 lbs. 9.1 lbs. 7.4 / 7.7 lbs. 7.7 lbs. 4.2 lbs.

INSTALLATION

For best results and a long service life, follow the instructions given in this manual.

POSITIONING

The InstaBlend is not permanently fixed in one location. It can be carried to the required location/area for use
where there is a suitable wall receptacle. Each unit is supplied with a wall for convenient storage.

InstaBlend - 16000 Series Ops Manual

3

OPERATION

Plug the appliance into a proper electrical outlet.

MODELS 16900, 16901, 16902, 16903

STARTING

Pressing the “Start” button (B) together with the
“Safety” button (D) will cause the machine to
start. The machine will not start if the “Safety”
button is not actuated. Releasing the “Start”
button will cause the machine to stop operating.

CONTINUOUS OPERATION

For continuous operation, while the machine is
running, press the “Lock” button (C). After the
“Lock” button is depressed, the “Start” button
may be released and the machine will continue to
operate. Pressing the “Start” button again will
shut off the machine.

Models 16902 and 16903 – The Speed Control
(A) may be adjusted to change the speed of the
blade or mixer.

MODEL 16904

STARTING

Pressing the “Start” button (1) together with the
“Safety” button (2) will cause the machine to
start. The machine will not start if the “Safety”
button is not actuated. After the machine has
started, the “Safety” button may be released and
the machine will continue to operate. Releasing
the “Start” button will cause the machine to shut
off.

BEST RESULTS

Best results are achieved by introducing the arm of the machine into the bowl, up to 2/3 of the arm’s length.

For optimum operation, it is better if the foot of the machine does not touch the bottom of the bowl.

In order to prevent splashed food from getting inside the motor unit, it is recommended not to incline the appliance
more than 30°.

InstaBlend - 16000 Series Ops Manual

4

MAINTENANCE

TO AVOID ELECTRICAL SHOCK THAT CAN CAUSE SEVERE INJURY OR DEATH, ALWAYS UNPLUG
LIQUIDIZER / MIXER BEFORE PROCEEDING WITH ANY CLEANING OR MAINTENANCE PROCEDURES!

IN ORDER TO AVOID DAMAGE TO PEOPLE AND THE APPLIANCE, READ AND FOLLOW THE
MANUFACTURER’S INSTRUCTIONS FOR THE CLEANING OF THE LIQUIDIZER / MIXER.

DO NOT USE THE FOLLOWING PRODUCTS:

• Abrasive cleaners such as Ammonia, Lye, etc.

• Solvents

• Metal Scourers

• Gritty Detergents

These products would score, scratch and damage the metallic and plastic surfaces of the appliance.

WARNING

!

!

CLEANING PROCEDURE

All parts of the machine that come into contact with the food product should be cleaned immediately after each use.
Place up to 2/3 of the length of the mixer arm into hot water (95° F to 115° F) and switch on for a few seconds. The
mixer and blade must be cleaned with hot water and a mild detergent, leaving the blade with warm water to remove
any residue. Allow the mixer arm and blade to air dry.

The motor set must be cleaned with a damp cloth. Under no circumstances must water enter the motor set. If
water accidentally enters the motor set, dry the motor set carefully before switching on the machine.

After cleaning, place the machine in its wall support.

Models 16900, 16901, 16902, 16903:

The Liquidizer/Mixer arm may be removed for cleaning. To remove the Liquidizer/Mixer arm, turn the
Liquidizer/Mixer clockwise until the arm separates from the motor set. To reassemble, reverse the procedure.

InstaBlend - 16000 Series Ops Manual

5

ADDITIONAL INFORMATION

WARNING:

!

WARNING:

!

WARNING:

!

The airborne noise emitted by the appliance, as measured on a type appliance at a distance of one (1) meter is
less than 80dB(A).

In the event the power supply cord becomes damaged and has to be replaced, the repair
may only be completed by a Lincoln Authorized Service Agency. Information on Authorized
Service Agencies maybe obtained by calling Lincoln Technical Support at [phone].
DO NOT USE THE MACHINE IF THE POWER SUPPLY CORD IS DAMAGED.

In order to prevent injury or damage to the InstaBlend, never put utensils or hands into the
mixture.

The blade edges are sharp and care should be exercised when cleaning.

WARNING – SHOCK HAZARD: To reduce the risk of injury or death by electric shock:

!

1. Do not place or store where Liquidizer/Mixer can fall or be knocked into water or other liquid mixture.

2. If Liquidizer/Mixer falls into water or other liquid mixture, unplug immediately.
Do not reach into water or liquid mixture to retrieve.

3. Do not allow water or other liquid mixture to enter the motor housing slots when using or cleaning.

4.

Switch power “OFF” and disconnect from power source before cleaning and when not in use.

WARNING – SHARP OBJECTS: Machine uses sharp, rapidly moving mixing blades.
To reduce the risk of injury:

!

1. Immerse mixing blades before turning on the Liquidizer/Mixer.

2. Turn “OFF” Liquidizer/Mixer before removing blades from mixture.

3.

Avoid contact with moving blades.

InstaBlend - 16000 Series Ops Manual

6

This page intentionally left blank.

InstaBlend - 16000 Series Ops Manual

7

PARTS LIST
MODELS 16900, 16901, 16902, 16903

Number Description Spare Part # 16900 16901 16902 16903

1A Variable Speed Control 380067  
1B Speed Control 380066  

2 Hood Set 380069    
3A Motor Frame Set 380071  
3B Motor Frame Set 380077  

4 Reducing Frame Set 370075  

5 Blade Lower Locking Set 380057    

6 Whisks Shaft Set 380079  
7A Brush Set 380060  
7B Brush Set 380070  

8 Control Protectors Set 380064    
9A Motor Set 380074  
9B Motor Set 380072 
9C Motor Set 380073 
10 Bearings – Grommet Set 380055    

11A Blade Set 380058  
11B Blade Set 380061 

12 Arm Coupling Nut Set 380054    
13 Whisks Set 380080  

14A Arm Shaft 380056  
14B Arm Shaft 380062 
15A Turbine Protector 380059  
15B Turbine Protector 380063 

16 Power Cord 380068    
17 Coupling Set 380065    
18 Reducer Shaft 380076  
19 Wall Support 380078    

20

21

Not Shown Mixer Arm Assembly 380083  

Turbine Lock Key
(blade removal tool)

Liquid Arm Assembly – 21” 380081 
Liquid Arm Assembly – 15” 380082  

380084    

InstaBlend - 16000 Series Ops Manual

8

PARTS DIAGRAM
MODELS 16900, 16901, 16902, 16903

InstaBlend - 16000 Series Ops Manual

9

PARTS LIST
MODEL 16904

Number Description Spare Part # 16904

1 Wall Support Set 380052 
2 Switch, 2-Pole 380050 
3 Blade Set 380041 
4 Coupling Set 380042 
5 Lower Hood Set 380040 
6 Bearings-Grommets Set 380045 
7 Motor Set 380047 
8 Power Cord 380053 

9 Frames Set 380043 
10 Protectors and Screws Set 380048 
11 Shaft 380049 
12 Brush Set 380046 
13 Grinder Arm Set 380044 
14 Turbine Protector 380051 

InstaBlend - 16000 Series Ops Manual

10

PARTS DIAGRAM
MODELS 16904

InstaBlend - 16000 Series Ops Manual

11

SCHEMATIC DIAGRAMS

MODELS 16000, 16901

InstaBlend - 16000 Series Ops Manual

12

SCHEMATIC DIAGRAMS (CONT’D)

MODELS 16902, 16903

InstaBlend - 16000 Series Ops Manual

13

SCHEMATIC DIAGRAMS (CONT’D)

MODEL 16904

InstaBlend - 16000 Series Ops Manual

14

This page intentionally left blank.

InstaBlend - 16000 Series Ops Manual

15

Lincoln Foodservice Product, LLC

1111 North Hadley Road

Fort Wayne, Indiana 46804

United States of America

Telephone: [phone]

U.S. Fax: [phone]

Int’l Fax: [phone]

Technical Support Hotline: [phone]

www.lincolnsmallwares.com

InstaBlend - 16000 Series Ops Manual

16