Please make a note of your product details for
future use:
Date Purchased:_________________________
Model Number:__________________________
Serial Number:__________________________
Dealer:_________________________________
_______________________________________
Installation, Operating and Servicing
Instructions
Lynx 400 Electric Bains Marie
LBM, LBMW, LBM2, LBM2W, LBM3,
LBM3W, LRB, LRBW, LRB2, LRB2W, LRB3,
LRB3W
IS 307 ECN 3607 Page 1 of 7
CONTENTS
Important Information
2
Warnings and Precautions
3
Technical Data
3
Checklist of Enclosures
3
Installation and Commissioning
4-5
Operating Instructions
5
Cleaning
5
Servicing, Maintenance and Component Replacement
5
Fault Finding
5
Spare Parts List
6
Service Information and Guarantee
7
IMPORTANT INFORMATION
Read these instructions carefully before using this product, paying particular
attention to all sections that carry warning symbols, caution symbols and notices.
Ensure that these are understood at all times.
WARNING!
This symbol is used whenever there is a risk of personal injury.
CAUTION!
This symbol is used whenever there is a risk of damaging your Lincat product.
NOTE:
This symbol is used to provide additional information, hints and tips.
KEEP THIS MANUAL FOR FUTURE REFERENCE
IS 307 ECN 3607 Page 2 of 7
WARNINGS AND PRECAUTIONS
TECHNICAL DATA
Model
Height (mm)
Width (mm)
Depth (mm)
Weight (kg)
LBM, LBMW
196
285
400
6 / 7.5
LBM2, LBM2W
565
10.5 / 13
LBM3, LBM3W
850
14 / 17.5
LRB, LRBW
251
285
6 / 7.5
LRB2, LRB2W
565
10 / 13
LRB3, LRB3W
850
14 / 17
CHECK LIST OF ENCLOSURES
Item
Model
Warranty card
All
Instructions manual
Rubber feet
¼ Gastronorms & lids
LBM, LBMW x 2, LBM2, LBM2W x 4, LBM3, LBM3W x 6
Water tank
LBMW, LBM2W, LBM3W, LRBW, LRB2W, LRB3W
Spacers
LBM2, LBM2W x 2, LBM3, LBM3W x 4
8pt pots & lids
LRB, LRBW x 1, LRB2, LRB2W x 2, LRB3, LRB3W x 3
Hobtop insert
LRB, LRBW, LRB2, LRB2W, LRB3, LRB3W
This appliance must be installed, commissioned and serviced by a qualified person
in accordance with national and local regulations in force in the country of
installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person.
Ensure that the plug/socket is accessible at all times.
Strip plastic coating and clean the appliance before use.
During operation parts may become hot - avoid accidental contact.
Disconnect this appliance before servicing, maintenance or cleaning.
IS 307 ECN 3607 Page 3 of 7
INSTALLATION AND COMMISSIONING
This appliance must be earthed.
If replacing the plug connect the terminals as follows:
Green and Yellow wire Earth E
Blue wire Neutral N
Brown wire Live L
Supply cords shall be oil resistant, sheathed flexible cable not lighter than ordinary
polychloroprene or equivalent elastomer sheathed cord (code 60245 IEC 57)
Push rubber feet into base holes. Install this appliance on a level surface ensuring
all vents are unobstructed. Any partitions, walls or furniture must be of noncombustible material. Minimum distances A 100mm B 1000mm – see Fig 1.
Fig 1
IS 307 ECN 3607 Page 4 of 7
Power Ratings
Model
kW
Amps
LBM, LBMW
0.25
1.1
LBM2, LBM2W
0.50
2.2
LBM3, LBM3W
0.75
3.3
LRB, LRBW
0.25
1.1
LRB2, LRB2W
0.50
2.2
LRB3, LRB3W
0.75
3.3
OPERATING INSTRUCTIONS
CLEANING
SERVICING, MAINTENANCE AND
COMPONENT REPLACEMENT
FAULT FINDING
Only qualified or trained personnel should use this appliance.
Connect the appliance to an electrical supply. The green neon indicates power to
the appliance.
For wet well models, fill the tank with water to a level between the minimum and
maximum markers at the rear of the tank. Ensure water level is maintained.
Turn the control knob to the desired setting.
Do not use a water jet or steam cleaner, and do not immerse this appliance.
Clean all panels with warm water and mild detergent, do not use abrasive
materials. Dry with a soft cloth.
All servicing, maintenance and component replacement on this appliance should be
carried out by one of our recommended service engineers.
Please refer to the Service Help Desk number on the final page of this manual.
IS 307 ECN 3607 Page 5 of 7
Part Number
Description
Used on
EL214
Element
LBM, LBMW, LRB, LRBW, LRB3, LRB3W,
LBM3, LBM3W
EL217
Element
LBM2, LBM2W, LRB2, LRB2W, LRB3, LRB3W,
LBM3, LBM3W
EN10
Energy regulator
All
KN237
Control knob
NE43
Neon
PL201
Plug & lead
SB24
Support bar
LBM2, LBM2W, LBM3, LBM3W
TA23
Round pot & lid
All LRB models
TA37
Gastronorm lid
All LBM models
TA42
¼ Gastronorm
All LBM models
SPARE PARTS LIST
IS 307 ECN 3607 Page 6 of 7
Product code
All available on serial plate
Type number
Serial number
SERVICE INFORMATION
For help with the installation, maintenance and use of your Lincat equipment,
please contact our service department:
UK: 01522 875520
For non-UK customers, please contact your local Lincat dealer
All service work, other than routine cleaning should be carried out by one of our
authorised service agents. We cannot accept responsibility for work carried out by
other persons.
To ensure your service enquiry is handled as efficiently as possible, please tell us:
Brief details of the problem
Lincat reserve the right to carry out any work under warranty, given reasonable
access to the appliance, during normal working hours, Monday to Friday, 08:30 to
17:00.
GUARANTEE
This unit carries a comprehensive UK mainland 2 year warranty. The guarantee is
in addition to, and does not diminish your statutory or legal rights.
The guarantee does not cover:
Accidental damage, misuse or use not in accordance with the manufacturer’s
instructions
Consumable items (such as filters, glass, bulbs, slot toaster elements and door
seals.)
Damage due to incorrect installation, modification, unauthorised service work or
damage due to scale, food debris build-up, etc.
The manufacturer disclaims any liability for incidental, or consequential damages.
Attendance is based on reasonable access to the appliance to allow the authorised
technician to carry out the warranty work.
Service calls to equipment under warranty will be carried out in accordance with the
conditions of sale. Unless otherwise specified, a maximum of 15 minutes of
administrative time, not spent directly carrying out servicing work, is provided for
within the warranty. Any requirement for staff attending the call to spend greater time
than 15 minutes due to administrative requirements, such as on health and safety risk
assessments, will be chargeable at the prevailing rate.
IS 307 ECN 3607 Page 7 of 7
Loading...