LightwaveRF JSJS LW600 Operation Manual

Energy Monitor

Operation Manual

Model No’s: JSJS LW600

OVERVIEW:

connect

IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE AND FOR GUIDANCE ON
THE ASSOCIATION OF REMOTE HANDSETS. FOR
HELP AND SETUP GUIDANCE PLEASE VISIT
www.lightwaverf.com

It is important to install this product in accordance
with the tting instructions below. Failure to do so
may render your guarantee void.

KEY

1. LED to indicate the data transmission

2. Battery compartment

3. Sensor cable sockets (3pcs)

This device enables you to view your current
electricity usage using a smartphone, iPod Touch/
iPhone/iPad or a PC webpage (not included). This
product must be used in conjuction with a
LightwaveRF Connect Wi-Link and wireless router
(not included).

INSTALLATION:

WARNING!

Extreme care must be taken when working with
electrical equipment as touching exposed electrical
wires may result in electrocution. If you are in any
doubt, please consult a qualied electrician.

Attaching the transmitter

1. Locate Electricity Meter and identify live supply
cable.

2. Visually inspect the insulation (plastic covering)
to ensure no damage or deterioration such as
cracks in the outer covering, visible copper cores
etc.

3. Firmly attach the sensor around the cable using
the self-locking cable clamp.

4. Insert the 2 X AA batteries into the transmitter.

5. Attach the transmitter to the wall using the wall
mount kit provided, ensuring that the length of the
sensor cable will reach the location of the
transmitter.

SETUP:

The Energy monitor is designed to work in
conjunction with the LightwaveRF Connect Wi Link.
Please refer to the Wi-Link setup instructions for
guidance on how to install and setup the app or web
console.

PAIRING THE ENERGY MONITOR

Once you have set up the Wi-Link and installed the
Energy Monitor, you will need to pair the two
together.

1. Ensure that you are in RF range of the device when
setting up (generally within the home is acceptable
range).

2. On the Wi-Link Menu screen, press one of the
green buttons to scroll across until ‘Energy Monitor’
is displayed. Press the green button next to the word
‘install’.

3. Press the green LED button on the Energy Monitor.
The LED should ash green to indicate a successful
pairing. The monitor is now paired with the Wi-Link.

OPERATION:

Once you have paired the Energy Monitor and
Wi-Link, after around 30 seconds the monitor will
start to send data to Wi-Link which will be displayed
on the LCD screen.

The energy data can also be displayed on the
LightwaveRF app or PC web console. As long as your
device is registered with the Wi-Link, you should
automatically be able to see the live data by
migrating to the ‘Ecometer’ tab (there may be a short
delay when you rst view the page).

You can adjust the electricity tari cost calculations
by choosing ‘Comm Settings’ and then ‘Eco Meter’ on
the settings tab of the app. For guidance on how to
do this using the web console please follow the
online instructions.

Battery Replacement

Requires 2 AA batteries (not included). When battery

voltage is low, the transmission range may
become poor and meter readings may be
unreliable. Slide down the battery cover and replace

with a fresh new battery.

Birmingham Science Park Aston

Faraday Wharf

Holt Street

Birmingham

B7 4BB

Tel: [phone]

Email: [e-mail]

SPECIFICATION:

RF frequency: 868 Mhz
Range: >30m
Power supply: 3V (2 x AA batteries)
Blue LED indicator
Operating Environment:
Operating temp: 0°C-50°C
Storage temp: 0°C-70°C