LightwaveRF JSJS LW104 Operation Manual

Mood Remote

Operation Manual

Model No: JSJS LW104

OVERVIEW:

connect

IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE AND FOR GUIDANCE ON
THE ASSOCIATION OF REMOTE HANDSETS. FOR
HELP AND SETUP GUIDANCE PLEASE VISIT
www.lightwaverf.com

It is important to install this product in accordance
with the tting instructions below. Failure to do so
may render your guarantee void.

Mood 3
Mood 2
Mood 1
All O
On
O
Channel
Selector

SETUP:

The functions illustrated here relate to the operation of
ON/OFF receivers such as Single and Double Sockets
and the Plug-in Adapter Sockets, and to dimmable
receivers; for information regarding how to pair the
handset to the relevant receiver(s), please refer to the
setup instructions for that individual device.

Before operation, ensure that the plastic lm isolating
the battery is removed (see later battery replacement
diagram for guidance on how to access battery).

NOTE: If the RF range between the transmitter and
receiver is too great to achieve reliable operation, the
LightwaveRF Connect SIGNAL BOOSTER may be used
in conjunction with this product to increase the signal
strength over greater distances.

IMPORTANT: On the Mood Remote there is a slider
labelled ABCD. Sliding between the letters allows you
to pair LightwaveRF devices to separate channels
(A,B,C or D). Which ever position the slider is in when
you pair the remote to the LightwaveRF device it will
be paired to THAT channel. You can then turn your
devices on or o independently using the same set of
on/o keys with the slider in the relevant position. You
can also pair multiple devices to the SAME channel.
Every device that you pair to the remote will become
part of your mood selections regardless of which
channel it is paired to.

OPERATION :

‘ON’ Button - Press once to switch paired devices ‘ON’.

Hold to raise dim level.

‘OFF’ Button - Press once to switch paired devices ‘OFF’.
Hold to lower the dim level.

On

Setting Moods Using the Mood Remote

1. Ensure that LightwaveRF devices (CFRs /dimmers/
sockets etc.) that you wish to include in the ‘mood’ are
paired with the Mood Remote (they can be paired to
any channel - A,B,C or D).

2. Using the Remote, or via manual control, set the
status (on or o) and dim level of the devices that you
want to include in the mood.

3. When you are satised with the current setup,
press and hold one of the Mood buttons. The LEDs
on any devices paired with the Mood Remote will
ash to indicate that the Mood is now set.

4. Press the ‘All O’ Button to turn o the mood. To
return to the saved mood at any time simply press the
relevant mood button once again.

5. Repeat the process for other mood buttons to
create multiple mood settings.

O

Birmingham Science Park Aston

Faraday Wharf

Holt Street

Birmingham

B7 4BB

Tel: [phone]

Email: [e-mail]

SPECIFICATION:

RF frequency: 433.92 MHz
Battery: 3V CR2032 lithium cell battery operated
(included)
Blue LED indicator