LightwaveRF JSJS LW100 Operation Manual

Handheld Remote

Operation Manual

Model No’s: JSJS LW100

OVERVIEW:

connect

IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE AND FOR GUIDANCE ON
THE ASSOCIATION OF REMOTE HANDSETS. FOR
HELP AND SETUP GUIDANCE PLEASE VISIT
www.lightwaverf.com

It is important to install this product in accordance
with the tting instructions below. Failure to do so
may render your guarantee void.

SETUP:

The functions illustrated here relate to the operation
of ON/OFF receivers such as Single and Double
Sockets and the Plug-in Adapter Sockets, and to
dimmable receivers; for information regarding how
to pair the handset to the relevant receiver(s), please
refer to the setup instructions for that individual
device.

Before operation, ensure that the plastic lm
isolating the battery is removed (see later battery
replacement diagram for guidance on how to access
battery).

NOTE: If the RF range between the transmitter and
receiver is too great to achieve reliable operation,
the LightwaveRF Connect SIGNAL BOOSTER may be
used in conjunction with this product to increase the
signal strength over greater distances.

Setting a Mood

To set up a mood:

1. Make sure all of the devices that are to be
incorporated into the mood are paired with the
mood remote (see relevant receiver device
instructions for details of how to do this).

2. Set the desired output status (i.e. ON or OFF) or
dim level of all of the receivers to be incorporated
into the mood – this is how they will appear
when the mood is activated.

3. Hold down the ‘Mood’ button for 5 seconds.

4. The handset LED will ash for 3 seconds.

5. The Handset will then send a ‘store mood’ code to
all paired receivers, which will ash to show
conrmation.

OPERATION :

1) Linked to an ‘ON/OFF’ receiver (eg Room
Control single, double or plug-in sockets):

‘ON’ Button - Press once to switch ‘ON’.

‘OFF’ Button - Press once to switch ‘OFF’.

‘ALL OFF’ Button - Press once to switch o all paired

receivers at the same time.

!

2) Linked to a ‘Dimmer’ receiver (e.g. Room Control
Single Dimmer or dimmable CFR):

Lowering Dim Level

1. Make sure the light is switched on.

2. Hold down the ‘OFF’ button.

3. After 1 second the light will start to dim.

4. At the desired brightness level release the ‘OFF’
button.

NOTE: If the ‘OFF’ button is not released, the light will
continue to dim until it reaches its lowest possible
level (without being turned o) and stop.

Raising Dim Level

1. Make sure the light is switched on.

2. Hold down the ‘ON’ button.

3. After 1 second the light will start to become
brighter.

4. At the desired brightness release the ‘ON’ button.

NOTE: If the ‘ON’ button is not released, the light level
will increase until it stops at the maximum possible
level of brightness.
After setting a dim level using the handset the light is
then switched o. The next time the light is switched
back on again the dim level will automatically return
to the previously stipulated setting.

BATTERY REPLACEMENT:

3V CR2032 lithium battery is included.
When battery voltage is low, transmission is low.
Slide down the battery cover and replace with a fresh
new battery.

NOTE:

• Connect correctly and securely

• Do not recharge

• Keep away from children

• Do not swallow (If swallowed, seek medical advice

immediately)

• Please dispose of used batteries responsibly

Birmingham Science Park Aston

Faraday Wharf

Holt Street

Birmingham

B7 4BB

Tel: [phone]

Email: [e-mail]

SPECIFICATION:

RF frequency: 433.92 MHz
Battery: 3V CR2032 lithium cell battery operated
(included)
Blue LED indicator