Installation - general safety instructions
CAUTION - DANGER OF ELECTROCUTION
Only appropriate technical personnel may work on electrical systems. There is a risk of fatal electrocution.
Before working on electrical systems and switching units, they should be removed from the power supply
and secured against accidental re-connection. Before touching conductive components and cables, use appropriate equipment to confirm they are actually isolated from the power supply.
First read the operating instructions through completely, as they contain important information for correct
fitting and operation.
Any damage caused by non-compliance with these operating instructions invalidates the warranty/guar-
antee! We do not accept any liability for direct or consequential damages!
We do not accept any liability for personal or property damage caused by improper use or non-compli-
ance with the safety instructions! In these cases, the warranty/guarantee is invalidated!
The product may not be opened (please also read the instructions in the chapter MAINTENANCE).
The light source in these luminaires is not replaceable. When the light source has reached the end of its
life, the whole light must be replaced
Do not install the product on a damp or conductive surface.
To avoid any hazard, a damaged outer flexible lead on this light may only be replaced by the manufac-
turer, their representative or a comparable qualified person.
Only install the product in switched-off mode.
Only install the product in intended electrical systems and voltage ranges. Check and compare the infor-
mation on this on the product’s type plate.
If a fault occurs, disconnect the product from the mains power supply and any other connected devices.
Then ensure neither can be switched on again accidentally.
If you cannot guarantee that the product can be operated without any danger, disconnect the product
immediately from the mains power supply and any other connected devices. Once more, ensure neither
can be switched on again accidentally. It is not possible to guarantee that the product can be operated
without any danger when, for example, the housing or power cable is damaged, or if any foreign objects
have penetrated it.
Use suitable, approved power cables and cable connectors / clips of an adequate size. Make sure the
cables sit firmly in the connectors. Any loose or exposed cables represent an extremely high risk of electric shock and fire.
When working under roofs, on masts or any other high fitting sites, ensure you are on a solid base by
using approved, certified ladders, or risers, as well as fall protection for personnel, tools and the product
to be installed. Cordon off the area under the installation area adequately.
Caution: Please consult specialists before using the luminaires in high ambient temperatures or chemi-
cally polluted environments.