How it Works
Lightronics
Loading...
FXLD354WAO
Owner's Manual
6 pgs373.99 Kb0

Lightronics FXLD354WAO Owner's Manual

Download
Page 1
Page 1 of 6 FXLD354WAO LED FIXTURE
Version 0.1 OWNERS MANUAL 05/07/2012
FEATURES AND SPECIFICATIONS
DESCRIPTION
The FXLD354WAO is a PAR Style white/amber LED lighting fixture. It is suitable for stage, disco, night club, and other artistic applications. It has several stand alone control modes and can operate via a DMX­512 external signal.
A double yoke enables the fixture to be operated in several positions.
INSTALLATION
LOCATION
The FXLD354WAO is rated IP65 and can be use outdoors
.
Locate the unit in a well ventilated area away from heat. Holes are provided on the yokes to install a lighting bar pipe clamp. Use a safety cable.
POWER CONNECTIONS
The FXLD354WAO has a line cord for connection to a 120 VAC, 15 Amp, 60Hz, grounded service. A pass thru power cable is also included.
You are limited to 6 fixtures when chaining power using the pass thru cables.
RISK OF ELECTRIC SHOCK
The safety ground pin on the power cord must be used.
DANGER
RISK OF FIRE
DMX CONNECTIONS
A system using DMX control should be connected as a chain of devices. In other words the control signal cable should proceed from the controller to the first receiving device and then to others in a continuous "daisy chain" fashion.
The fixture has a DMX IN and a DMX OUT connector to be used to connect the chain. The cable should NOT be split into a star arrangement with a cable running from the controller directly to each fixture.
www.lightronics.com Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
Page 2
Page 2 of 6 FXLD354WAO LED FIXTURE
Version 0.1 OWNERS MANUAL 05/07/2012
DMX CONNECTOR PIN ASSIGNMENTS
There are two different connectors which can be used for DMX control. They are both XLR type connectors. Some units use 3 pin connectors. Others use 5 pin connectors. The FXLD354WAO receives a DMX signal on the 3 pin MALE connector on one side of the unit. The 3 pin FEMALE connector is used to connect the next DMX device on the control chain. If your console uses a 5 pin connector you can make up an adapter cable to accommodate this. The table below shows the pin assignments for BOTH the 3 pin and 5 pin connectors.
DMX TERMINATION
IN # SIGNAL NAME
1 DMX COMMON 2 DMX DATA ­3 DMX DATA + 4 NOT USED 5 NOT USED
A DMX chain should be terminated at the last receiving device on the chain. This is done by installing a commonly available 1/4 Watt, 120 Ohm resistor across the DATA - and DATA + wires at the last device. If you have only a few fixtures very close together and a very short run to the controller then you may be able to operate without the terminator.
OPERATION
A control panel on rear of the unit is used to set the operating options. It consists of an LED display and four buttons
(MENU, ENTER, UP, and DOWN).
CONTROL PANEL
MENU
UP DOWNENTER
Push
MENU
to access the operating options. Then use
UP
and
DOWN
to scroll through the available choices. When you reach the option you want to set or change ­push
ENTER
. Now you can view the current setting
for the option and/or change it. Push MENU to save
your changes and activate the option. See the "MENU NAVIGATION" diagram for additional details.
There are 9 operation modes: DMX, Amber Level, White #1 Level, White #2 Level, Flash, Fade, Auto Sequence, Sound Color, and Sound Flash.
DMX OPERATION
Use the Addr menu to set the starting address of the unit. You can set the starting address of the unit with the UP and DOWN buttons.
The fixture uses four channels allocated as follows:
CHANNEL 1: Master Dimmer + Strobe Effects CHANNEL 2: Amber Level CHANNEL 3: White 1 Level CHANNEL 4: White 2 Level
Additional detail on DMX channel operation is given in the table "DMX Values and Functions".
MANUAL OPERATION
For manual operation the, amber and two white LED group intensity levels may be independently controlled. Use the Ab - -, 3L - -, and 3
L
- -, menus to set the
levels. The range is from 00 (OFF) to 12 (Full On).
FLASH OPERATION
This option strobes the colors which have been set. manually. Use the FLAS menu to select the strobe speed. The range is from 00 to 12. 12 is fastest.
FADE OPERATION
This option fades smoothly through the colors which have been set manually. Use the FAdE menu to set the speed and activate the option. The range is from 00 to
12. 12 is fastest.
AUTO SEQUENCE (COLOR CHANGE)
This option sequences through all the color combinations at max. brightness. Use the ASC- menu to set the speed. The range is from 00 to 12. 12 is fastest.
www.lightronics.com Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
Page 3
Page 3 of 6 FXLD354WAO LED FIXTURE
Version 0.1 OWNERS MANUAL 05/07/2012
SOUND OPERATION
Sound operation has a Color and a Flash sub-mode. Use the SOUA menu to invoke the Sound Color
option. The unit will sequence through a series of colors in sync with music base notes.
Use the SOUF menu to invoke the Sound Flash option. The unit unit will flash through a series of colors in sync with music base notes.
MAINTENANCE AND REPAIR
DISCONNECT ALL POWER AND CONTROL CABLES BEFOR HANDLING THE UNIT
TROUBLESHOOTING
RISK OF ELECTRIC SHOCK
DANGER
RISK OF FIRE
Check that you have power applied to the unit. Check the DMX control cable. Check the address settings of the unit and the
controller.
CLEANING
Do not use harsh chemicals or solvents when cleaning the fixture. A mild detergent can be used sparingly if needed. Ensure that the unit is completely dry before re-use.
REPAIR
The FXLD354WAO does not contain parts which are serviceable by the user.
Internal service on the unit by other than Lightronics authorized agents will void the warranty.
If service is required, contact the dealer from whom you purchased the item, or contact the Lightronics, Service Department, 509 Central Drive, Virginia Beach, VA 23454. Tel: 757 486 3588.
PHOTOMETRIC CHARACTERISTICS
Distance Illuminance Beam Diam. (ft) (Lux) (ft)
10 1460 4 20 376 8 30 172 10
www.lightronics.com Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
Page 4
Page 4 of 6 FXLD354WAO LED FIXTURE
Version 0.1 OWNERS MANUAL 05/07/2012
MENU NAVIGATION
www.lightronics.com Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
Page 5
Page 5 of 6 FXLD354WAO LED FIXTURE
Version 0.1 OWNERS MANUAL 05/07/2012
DMX VALUES AND FUNCTIONS
DMX
CHANNEL
1
DMX
VALUE
0 - 127 128 - 249 250 - 255
Master Dimmer for CH 2 - 4 Strobe Master for CH 2 - 4 Enables full range for CH2 - 4
2 0 - 255 Amber Level 3 0 - 255 White Group #1 Level 4 0 - 255 White Group #2 Level
FUNCTION
www.lightronics.com Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
Page 6
Y
This products is warranted for a period of TWO YEARS from the date of purchase against defects in materials and workmanship.
This warranty is subject to the following restrictions and conditions:
A) If service is required, you may be asked to provide proof of purchase from an authorized Lightronics dealer.
B) This warranty is valid only for the original purchaser of the unit. C) This warranty does not apply to damage resulting from abuse, misuse, accidents,
shipping, and repairs or modifications by anyone other than an authorized Lightronics service representative.
D) This warranty is void if the serial number is removed, altered or defaced. E) This warranty does not cover loss or damage, direct or indirect arising from the use or
inability to use this product. F) Lightronics reserves the right to make any changes, modifications, or updates as
deemed appropriate by Lightronics to products returned for service. Such changes may be made without prior notification to the user and without incurring any responsibility or liability for modifications or changes to equipment previously supplied. Lightronics is not responsible for supplying new equipment in accordance with any earlier specifications.
G) This warranty is the only warranty either expressed, implied, or statutory, upon which the equipment is purchased. No representatives, dealers or any of their agents are authorized to make any warranties, guarantees, or representations other than expressly stated herein.
H) This warranty does not cover the cost of shipping products to or from Lightronics for service.
I) Lightronics Inc. reserves the right to make changes as deemed necessary to this warranty without prior notification.
WARRANT
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 20100211
Loading...
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use