Lightolier V7010, W7011, W7010, W7009, V7011 User Manual

T

INSTALLATION OF CALCULITE A-LAMP WALL WASHER/DOWNLIGHT REFLECTOR

INSTRUCTION SHEE1’ FOR ITEMS:

V7009. V701O. V7011

W7009; W701O, W7011

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the Nationai Electrical Code and local or federal code specifications. TO prevent
electrical shock, turn off electricity at fuse box before proceeding,

Retain these instructions for maintenance referance.

INSTRUCTION SHEET NO.

IS:V7009

4

I-too

1Uuu

WALL WASHER
REFLECTUVHOUSING —\

DOWNLIGHT

MOUNTING FRAME -

WARNING+RISK OF FiRE)DO NOT INSTALL1NSULATIONWITHIN3 lNCHESOF FIXTURESIDES OR

WIRINGCOMPARTMENT,NOR ABOVEFIXTUREIN

I

A. INSTALL INSIDE REFLECTOR (FIG. 1)

NOTE For overlapping trim installation slip on WHITE

TRIM RING over INSIDE REFLECTOR, as shown in Fig.
2 and 3. For flangeless trim installation, WHITE TRIM
RING is not required.

To install INSIDE REFLECTOR in REFLECTOR/
HOUSING with THUMB SCREWS (Fig. 4), push INSIDE
REFLECTOR up into REFLECl_OR/HOUSING. Rotate
INSIDE REFLECTOR so that CUT OUT WINDOW is
always opposite the wall to be lighted. Now, tighten the
THUMBSCREWS so that INSIDE REFLECTOR is held
firmly against ceiling surface.

= CARDBOARD PAINT SHIELD

FIG. 1

SUCH A MANNER SO AS TO ENTRAP HEAT.

— LAMPHOLDER SPRING

~ ADJUSTABLE LAMPHOLDER HOUSING

/

SPRING

BOX

INSIDE
REFLECTOR ~

FIG. 2

J

(2

WHITE J

TRIM
RING

FIG. 3

1

r

B. CARE AND MAINTENANCE OF “A12AK”

REFLECTOR
If handling of reflectors with anodized or Alzak finish is

required, the use of clean white or plastic film gloves is
recommended to avoid fingerprints.

Anodized or Alzak surfaces can be cleaned by the
followina methods:

Wipe”of with a soft, clean, dry, lint-free cloth.
Wipe off with a clean cloth dampened in mild
detergent solution. Rinse, then wipe dry with lint-free
cloth or paper towel.
WiDe off with a clean cloth damDened with a
soiution of wetting agent and water (such as 2 oz.
per gallon “Piuronic L62-LF by Wyandotte Products),
or a liquid wax such as Glass Wax”. Then wipe dty.
Avoid gritty cleaning agents.

U.S. Pat. No. 4,039,822

‘HUMBSCREWT rREFLEmOR’HOus’NG

CUT OUT —
WINDOW

1

FIG. 4