Lytecaster
®
Recessed Downlighting 1102TM1
Page 1 of 1 6 3/4 ” Aperture Low Profile 2 Lt. 13W Emergency Fluorescent Frame-In Kit
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit Reflector Trims — See Individual Reflector Trim Specification Sheets
Cone Baffles Cross Blade
1102TM1 HPF 120V 1113TGD 1105T 1132T 1126T 1135T
1102TM2 HPF 277V 1113TCL 1105TWH 1128T
Features
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick. Low profile 3 7/8" depth including ceiling material and
reflector trim. For ceilings thicker than 5/8", depth from finished ceiling will
be ceiling thickness (max. 1") plus 3 1/4". Push-in/twist-out rotoclips hold
reflector flush to ceiling.
2. Junction Box: .063" (#14 ga.) galvanized steel. Rated for 8 #12 AWM
through branch circuit wires suitable for 90° C, for end of run 75° C. Quick
release “L” shaped cover for access to wiring. Integral cable clamps permit
attachment of nonmetallic Romex®or armored cable without need of
additional connectors.
3. Mounting Bars: Die-formed steel, #16 ga. Four bars, 13" long, extend to
27", permit off-center mounting; bars rotate 90° and lock in both directions;
integral poised nailer for wood joists, locking tabs for T-bar runners.
4. Socket Housing: 22 ga. galvanized spring steel; snap-in quick assembly for
precise lamp location.
5. Socket: Two-pin base, molded thermoplastic; prewired with #18 AWM leads
to 4" x 3 1/2” x 2" junction box.
6. Thermally Protected Ballast: 2 light electromagnetic, encased and potted,
class "P" high power factor. Insulation must be kept 3" away from fixture
sides and wiring compartment and must not be placed above fixture as to
entrap heat.
7. Emergency Power Pack: Electronic, fully encased and pre-wired nickel
cadmium long life battery, replaceable from below. Meets requirements of
National Electric Code and Life Safety Code. Test switch and charge light
included in easy to install recessed switch box with 4 1/2” diameter matte
white cover plate, 24" long flexible cable; may be installed up to 50 feet from
fixture. One lamp operates at 61% initial output for 90 minutes when power
fails.
Open Downlight
Enclosed
Diffusers
1178T
Wall
Washer
Electrical
120V 277V
HPF Input Watts 31 42
Amps 0.28 0.17
Minimum starting time is 32° F.
Options & Accessories
Concealed Spline Ceiling Kit: 1965 - set of (4), 1 1/2” to 2 1/2” Mtg. Ht.
Plaster Ceiling Ring: 1961 - 7/8" depth for wet plaster ceilings.
Labels
UL (Suitable for Damp Locations), I.B.E.W.
Romex®is a registered trademark of General Cable Industries Inc.
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lightolier a Genlyte company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2011 Genlyte Group LLC • F0711
Loading...