Lightolier Lytecaster 1100AICMFT Specification

Lytecaster

®

Recessed Downlighting 1100AICMFT

Page 1 of 1 6 3/4”Aperture Fluorescent 1 Lt. 26/32W Triple Tube Insulated Ceiling, AirSeal® Frame-In Kit

1 6

Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.

Overall width: 9”

Frame-In Kit Reflector Trims — See Individual Reflector Trim Specification Sheets

Open Downlight

Reflector Satin Baffles Basic Pinhole
Cone White

1100AICMFT Cone: 1108 1105 Cone: 26W - 32W
1112 1108NM 1105NM 1113WH PL-T by Philips
1112NM 1110 1105BNM Reflector: DULUX by Osram Sylvania
1113 1110NM 1176 Triple BIAX by GE
1113CD 1176WH
1113NM
1113BKNM
1113CDNM

Reflector: Reflector: 1121 26W
1143 1170M1 1124 1185 PL-T by Philips
1144 1171 1134 1186 DULUX by Osram Sylvania
1144CD 1177SH 1186WH Triple BIAX by GE
1178SH

1126 26W
1128 PL-T by Philips

Enclosed Wall Wattage
Diffusers Washer & Lamp Type

Features

1. Housing: .026” galvanized steel. UL listed for direct contact with thermal

insulation. AirSeal® housing minimizes air leakage to less than 2 CFM at

1.57 PSF, which complies with Model Energy Code (Section 602.3.3) and the
Washington State Energy Code (Section 502.4) and reduces heat loss and
condensation in ceiling. Access door for inspection of junction box.

2. Mounting Frame: .036 (#20 ga.) galvanized steel. Accommodates all ceil­ings up to 1” thick. 3/8” deep integral lip. Four slots are positioned 90°
apart to simplify alignment. Push-in/twist-out rotoclips hold reflector flush
to ceiling.

3. Junction Box: 2” X 4” X 4”: .063” (#14 ga.) galvanized steel. UL listed for
maximum of 6 No. 12 ga., 90° C through branch circuit conductors. Quick
release “L” shaped cover for outside access to wiring. Access door inside
of housing allows easy inspection of wiring without removal of housing.
Integral cable clamps permit attachment of nonmetallic Romex® or armored
without the need for additional connectors.

4. Mounting Bars: .059” (#16 ga.) galvanized steel. Bars pivot for easy
attachment and wire-in below ceiling line. Bars extend to accommodate 16”
to 24” O. C. joist spacing and feature integral nail for secure attachment to
wood construction. Attaches to T-bar ceilings without the need of accesso­ries.

5. Ballast: Electronic, encased and potted, thermally protected, Class “P”,
Normal Power Factor, 120V.

6. Socket: 4-pin Gx24q-3 base compact fluorescent. Pre-wired with #18 ga.
TFN leads to junction box.

Options & Accessories

Mounting Bars: 1976 - 13” set of (4).

Concealed Spline Ceiling Kit: 1965 - set of (4), 1 1/2“ to 2” Mtg. Ht.
Extra-Thick Ceiling Mounting Ring: 1967A - up to 2” thick ceiling.

Labels

UL Type I.C. (Suitable for Damp Locations);

Complies with Air Leakage Requirements as stated in the Model Energy Code
and the Washington State Energy Code.

AirSeal® is a registered trademark of Lightolier.
Romex® is a registered trademark of General Cable Industries Inc.

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):
Notes:

Lightolier a Genlyte company www.lightolier.com

631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]

We reserve the right to change details of design, materials and finish.

© 2011 Genlyte Group LLC • C0711