Lightolier L1PH User Manual

Operates incandescent, magnetic and electronic ballast fluorescent, high power factor compact fluorescent, and high intensity discharge (HID) lamp types.

How to Specify:

Unit 14.0 kVA

Battery 2,995 lbs.
Cabinet (1,358 kg)

Electronics 465 lbs.
Cabinet (211 kg)

Total System 3,460 lbs.

(1,569 kg)

L1PH Series Uninterruptible Power Supplies

L1PH

Page 1 of 2 14.0 kVA Single Phase UPS System

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:

Lightolier

a Genlyte Thomas Company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2004 Genlyte Thomas Group LLC (Lightolier Division) • D0504

Overall Characteristics

• 86% throughput efficiency

• Operating temperature range 32°F (0°C) to 104°F (40°C)

• Internal maintenance by-pass is standard

• Main load disconnect switch standard

• Double conversion, no interruption

• Standard backup time of 90 minutes, other run times optional

• Output circuit breakers and normally-off loads optional

Housing

• Free standing, NEMA 1 enclosure

• Acid resistant powder coat finish

• Multiple conduit entries

Metering/Controls

Standard

• Alpha-numeric front panel display with 14 metered measurements and
53 messages/alarms

• Normal, caution and alarm indicating LEDs

• Audible failure alarms with silence switch

• Dry contact for remote failure alarm

• “D” type 9-pin computer interface connector (see pin config. on back)

• Programmable battery monitor with alarm

Optional

• Diagnostics software for remote computer (PC) monitoring and control

• Stand-alone remote display mimics all measurements, indications and
alarms shown on the front panel display

• Additional RS-232 input/output port for remote monitoring and system
control

Electrical

• Sine Wave Output

• Completely solid-state Pulse Width Modulation (PWM) inverter

• 16-bit microprocessor control

• Input power factor correction maintains power factor at 0.99

• Transient response ≤ 5%; Recovery time, 10 mS (100% load step)

• 3:1 crest factor capability

• Inverter output distortion ≤ 2.5% THD (at unity power factor)

• Output voltage regulation ±6% of nominal at full load

• Frequency within ±0.05% of nominal

• Inverter efficiency ≥ 84%

• Load power factor capability is 0.5 leading to 0.5 lagging

(Continued on page 2)

NOTE: Input circuit
breaker not available.
Input switch is
standard.

L1PH I 14.0 S

SERIES INPUT SYSTEM BASE BATTERY OUTPUT OUTPUT # ON 2ND NORMALLY # OF NOL

VOLTAGE TYPE SIZE TYPE VOLTAGE CKT BRKRS1VOLTAGE OFF LOAD NOL VOLTAGE

L1PH = Single
Phase
Uninterruptible
Power
Supplies

14.0 = 14.0 kVa

2 = 208 V
3 = 240 V
4 = 277 V
Z = Special
Voltage

(Consult
Factory)

1 = 120 V
2 = 208 V
3 = 240 V
4 = 277 V
5 = 120/208 V
6 = 120/240 V
7 = 120/277 V
Z = Special
Voltage

(Consult
Factory)

Y = Hardwire
A = 1 0CB
B = 2 0CB
C = 3 0CB
D = 4 0CB
E = 5 0CB
F = 6 0CB
G = 7 0CB
H = 8 0CB
J = 9 0CB
K = 10 0CB
L = 11 0CB
M = 12 0CB
N = OCBA1
P = OCBA2
R = OCBA3
S = OCBA4
T = OCBA5
U = OCBA6
V = OCBA7
W = OCBA8
X = OCBA9

0
1
2
3
4
5
6
7
8

9
10
11

A = No
B = Yes
C = Yes w/ Time
Delay Timer

0 = No NOL
Y = Hardwire
Terminal
1 = 1
2 = 2
3 = 3
4 = 4
5 = 5
6 = 6
7 = 7
8 = 8
9 = 9
10 = 10
11 = 11
12 = 12

X = None
A = 1st
B = 2nd

I = ETL Listed
to UL 924 for
Emergency
Lighting
Applications

S = Sealed
Lead Calcium

34.0”

86.4 cm

33.0”

83.8 cm

70.0”

177.8 cm

Battery

Cabinet

33.0”

83.8 cm

30.0”

76.2 cm

43.5”

110.5 cm

Electronics

Cabinet

Electrical (continued from page 1)

• Automatic, battery protecting low voltage disconnect (LVD)

• Advanced battery diagnostics and management system

• Temperature compensated battery charger

• 24 hour recharge time

• High frequency, very low ripple current charger

• Input and output disconnect switch

• Battery disconnect switch

NOTES:

1) Continuous Duty

2) Total Load Not to Exceed System Rating

System Input/Output Ratings

Warranty

Standard Warranty
Lightolier will provide parts and on-site labor for the first 90 days following
shipment of product, and parts only for an additional 270 days.

Extended Warranty
(Available with purchase of Factory Start-Up Service) Lightolier will provide
parts and on-site labor for the first 12 months following start-up of the
product, and parts only for an additional 12 months.

System One-Line Diagram

Pin Description Function

8 Normal System Functioning Normally
6 Load On Reserve Double Conversion Inverter Not Operating
9 Power Failure Load Supplied by Battery
7 End of Discharge Period Unit Will Soon Stop Operating
5 Common Common Connection to Above 4 Signals

Computer Interface Pin Configuration

(AS/400™)

Listed to

UL 924

SYSTEM INPUT INPUT AVAILABLE OUTPUT VOLTAGES/ OCB POLE SPACES

RATING VOLTAGE AMPS

1

MAX. LOAD AMPS

2

AVAILABLE

120 V 208 V 240 V 277 V

14,000 VA 277 63.2 116.5 — — 50.5 12

208/240 80.8/70.0 116.5 67.3 58.3 — 12

L1PH Series Uninterruptible Power Supplies

L1PH

Page 2 of 2 14.0 kVA Single Phase UPS System

Lightolier

a Genlyte Thomas Company www.lightolier.com
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2004 Genlyte Thomas Group LLC (Lightolier Division) • D0504

Battery

Maintenance free, sealed lead calcium battery has an estimated service life of
10 years, and an operating temperature range of 65°F (19°C) to 85°F (30°C).

Options

0 = None
1 = PC Format Diagnostics Software
4 = Remote Display + “5”
5 = Additional RS-232

Job Information Type: