Lightolier IS-R7029 User Manual

INSTALLATION OF CALCULITE A-LAMP WALL WASHER/DOWNLIGHT REFLECTOR

INSTRUCTION SHEET FOR ITEMS:

P7006, P7007, P7008, Q7006, Q7007, Q7008, R7029, R7030, R7031,

S7029, S7030, S7031, T7032, T7033, ~034, U7032, U7033, U7034

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications. To prevent
electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance referance.

L MOUNTING SPRING

FIG. 1

IS:R7029

0888

WARNING—(RISK OF FIRE)DO NOT iNSTALLlNsuLATlON wlTHIN 3 INCHESOF FlxTuRE SIDES OR

WIRINGCOMPARTMENT,NOR

I

A. INSTALL INSIDE REFLECTOR (FIG. 1)

NOTE:

TRIM RING over INSIDE REFLECTOR, as shown in Fig.
2 and 3. For flangeless trim installation, WHITE TRIM

RING is not required.

1.2.To install INSIDE REFLECTOR in REFLECTOR/

B.CARE AND MAINTENANCE OF “ALZAK”

REFLECTOR

If handling of reflectors with anodized or Alzak finish is
required, the use of clean white or plastic film gloves is
recommended to avoid fingerprints.

Anodized or Alzak surfaces can be cleaned by the
following methods:

;.

3.

For overlapping trim installation slip on WHITE

HOUSING with SCREWS (Fig. 4), push INSIDE
REFLECTOR up into REFLECTOR/HOUSING. Align
keyslots in LOCKING RING and insert onto the

SCREWS on REFLECTOR/HOUSING. Rotate INSIDE

REFLECTOR clockwise so that CUT OUT WINDOW is
always opposite the wall to be lighted. Now, tighten
the SCREWS so that INSIDE REFLECTOR is held
firmly against ceiling surface.

To install INSIDE REFLECTOR in REFLECTOR/

HOUSING with THUMB SCREWS (Fig. 5), push

INSIDE REFLECTOR up into REFLECTOR/HOUSING.

Rotate INSIDE REFLECTOR so that CUT OUT
WINDOW is always opposite the wall to be lighted.

Now, tighten the THUMBSCREWS so that INSIDE

REFLECTOR is held firmly against ceiling surface.

Wipe-of with a soft, clean, dry, lint-free cloth.

Wipe off with a clean cloth dampened in mild

detergent solution. Rinse, then wipe dry with lint-free

cloth or paper towel.

Wipe off with a clean cloth dampened with a

solution of wetting agent and water (such as 2 oz.

per gallon “Pluronic L62-LF by Wyandotte Products),
or a liquid wax such as Glass Wax”. Then wipe dry.
Avoid gritty cleaning agents.

ABOVE FlxTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT.

WHITE _“

TRIM
RING

FIG. 2

REFLECTORI
HOUSING

REFLECTORI —

HOUSING

THUMBSCREW

CUT OUT ‘–~ ‘
WINDOW

7

FIG. 4

,-. ....=

I

i=

/

?~

9

i L.-~ ~

——.—

FIG. 5

~ LOCKING RING

‘\

. \,

INSIDE

‘<

REFLECTOR

U.S. Pat. No. 4,039,822

FIG. 3

I