Lightolier IS-LCAWTSX User Manual

IS:LCAWTSX

10-08/Rev-01

Installation Instructions for Lytespan Track LED DMX Control

Accent Lighting Colorspot Luminaire

CAUTION: Please read these instructions before installing the luminaire. To avoid electric shock, turn off the power from the electric panel before beginning. For safety, this
luminaire must be grounded. Consult an electrician to make sure all the requirements of the US or Canadian Code for electricity and the current local regulations comply. Keep these
instructions as reference.

WARNING: This luminaire is for ceiling installation on Lytespan track only. Do not install on Monopoint, Multipoint, Fast Track, Sloped Ceiling Adapter, Extension Wand or ProSpec

Track.

IMPORTANT: Do not expose this luminaire to a room ambient temperature more
than 28°C. An overheating of this luminaire could reduce the performance and the
time life os the light-emitting diode (LED).

Note: This luminaire uses a LED (Light Emitting Diode) light source,
no maintenance is required.

A. ONE-CIRCUIT TRACK INSTALLATION:

1. Align adapter lever open on bead side. (Fig.2 & 3)

2. Align locking lever 60° counter-clockwise. (Fig.3)

3. Insert luminaire module into the track. (Fig.4)

4. Turn adapter lever clockwise. (Fig.4)

5. Turn locking lever 60°. (Fig.4)

B. DOUBLE-CIRCUIT INSTALLATION:

1. Lift brass contact tab approximately ¼ in. (7mm). (Fig.5)

2. Follow previous steps 1-5.

C. FOR DMX CONTROL:

1. Simply connect data cable shielded CAT5 recommended into DMX connector or
insert RJ45e jack connector. (Fig.6)

2. For daisy chain data connection, connect data cable CAT5 into data-in socket of
the first luminaire, then connect the data cable to the data-out connector jack of
the next luminaire and so on. (Fig.7)

3. For signal termination, connect a DMX signal terminator to the data out of the
last luminaire in the network. (sold separately). (Fig.8)

Note: Hardware required for DMX control system. (not supplied)

Controller: DMX512 protocol.
Wiring: Use low-capacitance shielded twisted-pair stranded cables such as

EIA485 (RS485) or shielded CAT5.

- 24AWG: maximum run length of 300 m (1000 ft).

- 22AWG: maximum run length of 500 m (1600 ft).

Note: Using unshielded cable may create noise in the system and may cause

undesirable light output.

Connectors: RJ45e connector – 8 conductors (connections: T568B).

BEAD

ADAPTER

LEVER

ADAPTER
LEVER

DATA-IN SOCKET

RJ45e PLUG

FIG.2

LUMINAIRE MODULE

LOCKING LEVER

ADAPTER

LEVER

FIG.4

FIG.6

TRACK

FIG.1

INTERLOCKING LEVER

TRACK

FIG.3

BRASS CONTACT

FIG.5

Lightolier 631 Airport Road, Fall River, MA 02720, - Tel.: [phone] - Fax.: [phone] - www.lightolier.com

Canlyte 3015, Louis Amos, Lachine, Québec H8T 1C4 - Tel.: [phone] - Fax.: [phone] - www.canlyte.com

Lightolier is a Philips group brand

RJ45e PLUG

FIG.8

RJ45e PLUG

DMX TERMINATOR

DATA-OUT SOCKET

FIG.7