Lightolier IS-9060 User Manual
INSTRUCTION SHEET NO.
IS:9060
A0497 Page 1 of 1
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
JUNCTION BOX COVER FOR USE WITH
9100 SERIES, RADIUS
®
TRACK SYSTEMS ONLY
CAUTION:
• TURN OFF POWER AT FUSE BO X BEFORE INSTALLING TRACK.
• INSTRUCTIONS FOR GROUNDING MUST BE FOLLOWED.
FAILURE TO DO SO MAY RESULT IN AN ELECTRICAL HAZARD.
• USE SOLID 12 OR 14 GA. WIRES FOR SUPPLY TO TRACK (NOT STRANDED).
• OBSERVE POLARITY, WHITE SUPPL Y LEAD (NEUTRAL) T O TERMINAL MARKED “NEUT”.
®
FALL RIVER, MASSACHUSETTS 02720
MONTREAL, QUEBEC, CANADA
®
1. Mark centerline of track location through center of J-BOX.
Remove BOTTOM COVERfrom CONNECTOR.
2. Remove KNOCK OUT from TOP PLATE (Fig. 4)
3. Place CANOPY SPACER (Fig. 3) on TOP PLATE (Fig. 4).
4. Line up CROSSBAR (Fig. 2) with the T ABSon the CANOPY SPACER.
Mount CROSSBAR to CONNECTOR (Fig. 4) with SCREW. Connect
GROUND WIRE (Fig. 2) to GROUNDING TERMINAL in J-BOX. Pass
SUPPLY LEADSfrom OUTLET BOXthrough CROSSBAR center
hole and KNOCKOUThole in CONNECTOR.
5. Mount track to ceiling as shown in track Instruction Sheet
IS:9100. Secure the CROSSBAR to the J-BOX using the two
J-BOX SPECIAL SCREWSincluded (Fig. 2).
6. Slide the CANOPY between the CROSSBAR and CONNECTOR.
Optional:
a. Drill two 5/32” diameter holes in CANOPY DIMPLES.
b. Slide the CANOPY between the CROSSBAR and CONNECTOR.
c. Secure with COVER MOUNTING SCREWS. (Fig. 5)
7. Connect SUPPLY LEADSto TERMINALS in CONNECTOR as
shown in Instruction Sheet IS:9155.
The Junction Box Cover mounts to a Radius 9147WH, BK; 9151WH, BK; 9155WH, BK Connector for feed from an outlet box.
FIG. 3
CEILING
FIG. 4
F
IG. 2
F
IG. 1
F
IG. 5
CONNECTOR
BOT TOM COVER
3 ” OR 4 ” O CTAGONAL
J-BOX ( by others )
SCREW (1)
TOP PLAT E
CONNECTOR
CANOPY SPACER
CROSSBAR
COVER MOUNTING SCREW (2)
( optional)
CANOPY
DIMPLES
KNOCK OUT (removed )
GROUND WIRE
J-BOX SCREW (2) SPECIAL
Loading...