Lightolier IS-6706 User Manual

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local electrical
inspectorbefore installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTIONS FOR INSTALLATION OF DISCUS SURFACE MOUNT FIXTURES

INSTRUCTION SHEET NO.

IS:6706

Page 1 of 1A0200

Note: This instruction sheet covers several fixture styles.
Ceiling pan, assembly, lamp type, and diffuser may vary
from that shown, although installation is the same.

INSTALLATION (FIG. 1):

WARNING: (RISK OF FIRE) SUPPLY WIRING MUST BE RATED
90˚ C. FOR CEILING INSTALLATION OF MODELS 
6700MS213N1 & 6706MS213N1 ONLY. MOST DWELLINGS
BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED FOR 60˚ C.
CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALL

1. Make sure that power to OUTLET BOX is off.

2. Partially thread MOUNTING SCREWS supplied into

OUTLET BOX.

3. While supporting CEILING PAN make electrical connections:
black fixture lead to hot (black) supply lead; white
fixture lead to neutral (white) supply lead. Uninsulated
fixture wire is a ground wire and must be connected
to grounding terminal or ground lead inside OUTLET BOX.
Green fixture wire(s) must also be connected to
grounding terminal or ground lead inside OUTLET BOX.
Use WIRE NUTS (local hardware item). Push supply wires
and connections back into OUTLET BOX.

4. Position CEILING PAN over MOUNTING SCREWS and allow
head of MOUNTING SCREWS to come through KEYHOLE
SLOTS in CEILING PAN. Slide CEILING PAN until MOUNTING
SCREWS are fully engaged in narrow portion of KEYHOLE
SLOTS and secure in place by tightening MOUNTING SCREWS.

5. Install recommended lamp(s).

CAUTION: USE ONLY LAMP WATTAGE AND
  TYPE MARKED ON FIXTURE.

OUTLET BOX

WIRE NUTS

MOUNTING
SCREWS

CEILING PAN

DIFFUSER
BRACKETS

SLIDE

KEYHOLE SLOT

DIFFUSER

FIG. 1

OUTLET BOX

CEILING PAN

DIFFUSER
BRACKETS

DIFFUSER
NOTCHES

6. Align DIFFUSER NOTCHES with DIFFUSER BRACKETS on
CEILING PAN. Gently push DIFFUSER upward against
CEILING PAN and rotate clockwise until DIFFUSER is
locked in position.

7. To remove DIFFUSER, rotate counterclockwise until
DIFFUSER NOTCHES pass over DIFFUSER BRACKETS.

(FIG. 2):

DIFFUSER

UN-LOCK

LOCK

FIG. 2

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720