Lightolier IS-5543 User Manual

READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE

sfixtureisintendedfor installationinacmrdanmwiththeNational

assure full mmpfiance with local @ales and regulations, deck with your Iocsl electrical inspector before
,allation.

To prevent electrical shock, turn off electrify at fuse box before proceeding.

Retain these instructions for maintenance reference,

Electrical Code and IOCSIregulations.

INSTRUCTION SHEET NO.

IS:5543

1292 Page 1 of 1

INSTRUCTIONS FOR INSTALLATION

XTURE ASSEMBLY AND INSTALLATION:

1, Thread MOUNTING SCREWS intoOUTLET BOX.

2, Wtile supportingCEILING PAN make

or fixturelead withtracer mark 10(neutral)whitesupplylead. Uninsulatedwireis a groundand mustbe connectedto groundhgtarminalorgroundlead inside
OUTLET BOX, UseWIF?ENUTS(local hardware

3. PositionCEILING PAN overMOUNTING SCREWS andallowheadsofMOUNTING SCREWS tocomethroughtheKEYHOLE SLOTS inCEILING PAN.Secure

in place by tightening MOUNTING SCREWS,

4, Using the thrae AUXILIARY MOUNTING HOLES in CEILING PAN, secure CEILING PAN to ceiing using wood screws, toggle bolls,

provided) depending on ceiling material,

5, lnstdl recommend lamps by inseiling base of lamp into SOCKET and snapping lamp into LAMP SUPPORT CLIP,

CAUTION Use lamp waftage and type as marked on fixture,

6, Align holes in

KNOBS onto each MOUNTING STUDS,

)IFFUSER CLEANING AND REMOVAL:
)iffusercan be cleaned using a soft damp cloth, Should DIFFUSER need to be removed
.om diffuser ring for cleaning, follow steps below.

Whie gently pving back on one RETAINING SPRING (use a slotted screw diver)

push upon OIFFUSER allowing DIFFUSER to snap away from three RETAINING

SPRING (Ffg, 2).
!.’ Clean DIFFUSER.
1,’ Reinsfdl DIFFUSER bygeotly pushing DIFFUSER down into DIFFUSER RING until

all three RETAfNING SPRINGS engage on the edge of Ihe DIFFUSER and

DIFFUSER sits flush inside DIFFUSER RING.

DIFFUSERRINGASSEMBLYwithMOUNTINGSTUDSonCEILINGPANandallowSTUDStopasslhroughlheholes.Secure in place bylhreadhg

electrical connections black fixture lead orfixlurelead withouttracer marksto (hot)blacksupplylead;white fixturelead

item). Push supply wires and wirenutmnnecfions back intoOUTLET BOX.

oralternate fasleners (not

NOTE: If supply wires are locatedwithin three inches of

ballast, usewire rated

for at least 90° C.

WARNING-(RISK OF FIRE) MOST DWELLINGS

BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED
60” C. CONSULT A QUALIFIED ELECTRICIAN
BEFORE INSTALLATION.

DIFFu

FIG. i

1.1<5

I“ITC>I.IE la”EWH’,!W%YU