Lightolier IS-4170 User Manual
.
INSTRUCTIONSHEETNO.
INSTRUCTIONS
FIXTURES COVERED BY THIS INSTRUCTION SHEET 4170& 4171
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prsvent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
1. Thread MOUNTING STUDS into CROSSBAR.
Attach CROSSBAR to OUTLET BOX with
OUTLET BOX SCREWS.
2. Make connections Black fixture lead or fixture
lead without tracer mark to black supply lead;
white fixture lead or fixture lead with tracer
mark to white supply lead. Uninsulated wire is
a GROUND WIRE and must be attached to
ground terminal or GROUND WIRE in OUTLET
BOX. Use WIRE NUTS (local hardware item).
Place connections in OUTLET BOX.
3. Place CANOPY SUB-ASSEMBLY over
MOUNTING STUDS and tighten with CAP
SCREWS.
4. Install recommended lamps.
FOR ASSEMBLY AND INSTALLATION
IS:4170
osa9
(-r+rn~””’’m’”x
“0””” “RE~- -
5. Attach GLASS SHADE by looping WIRE
HARPS carefully over MOUNTING HOOKS
(Fig, 2).
STUD (Fig. 2).
FIG. 2
/0?
GLASS SHADE ~
LEVELING KNOB
LEVELING STUD
MOUNTING HOOK
I
WIRE HARP (2)
FIG. 1
\
\
!
‘ \wlREHARp
//
Loading...