Lightolier IS-406BLS User Manual

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

INSTRUCTI ON SHEET NO .

IS:406BLS

Retain these instructions for maintenance reference.

A0105 Page 1 of 1

INSTRUCTIONS FOR 6.5” PENDALYTE™ SERIES TRACK MOUNT TO LYTESPAN ® TRACK SYSTEM SUSPENSION

KITS. FOR USE WITH LYTESPAN TRACK SYSTEMS ONLY.

CAUTION: MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED.

POWER STEM INSTALLATION (fig. 1)

1. Slide STEM and BUSHING over POWERCORD. Align end of
POWERCORD with top of BUSHING tighten SET SCREW to secure
POWERCORD.

2. Twist stripped ends of POWERCORD wires an attach using CONTACT
SCREWS: attach hot (black POWERCORD lead to long BRASS
CONTACT, attach neutral (white) POWERCORD lead to short NICKEL
CONTACT, attach POWERCORD ground lead (green) to BODY with
green CONTACT SCREW.

3. Slide STEM up over contacts and secure to BODY using #4 SCREWS.

BODY

NICKEL CONTACT

#4 SCREWS

BRASS CONTACT

CONTACT
SCREWS

SET SCREW

STEM

POWERCORD

Fig. 1

BUSHING

TRACK

BEAD

Fig. 2

STEM LEVER

NOTE: Not for use with ProSpec track.

WARNING: TO PREVENT ELECTRIC

SHOCK, TURN OFF POWER TO TRACK.

INSTALLATION INTO TRACK (fig. 2)

1. Turn off power to TRACK.

2. Insert POWER STEM into track. The STEM LEVER must be on the
same side as the track bead. See fig. 2.

3. Rotate suspension stem 90° cl ockwise using STEM LEVER. STEM
LEVER should be parallel to TRACK.

4. To remove: rotate SUSPENSION STEM 90° counterclockwise using
STEM LEVER.

A

COMPANY

631 Airport Road, Fall River, MA 02720