Lightolier IS-406 User Manual
631 Ai
02720
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET FOR 6.5” PENDALYTE™
Note: This instruction sheet covers several luminaire styles. Powerh ead assembly, lamp type,
and reflector style may vary slightly from that shown, although installation is the same.
1. Remove CANOPY. Pull supply wires through hole in center of OUTLET BOX PLATE (Fig. 1) and
attach OUTLET BOX PLATE to outlet box using OUTLET BOX SCREWS (provided with outlet
box).
2. Pass CORD through hole in center of CANOPY.
3. Determine desired CORD length and attach RELIEF BUSHING to CORD with pliers. NOTE: Be
certain of CORD length before attaching RELIEF BUSHING as it is difficult to remove and
reposition.
4. Align HINGE on RELIEF BUSHING with HINGE MARK on CANOPY BRACKET (Fig. 2) and snap
into square hole in CANOPY BRACKET.
5. Tie KNOT in CORD above the CANOPY BRACKET.
6. To wire compact fluorescent unit see wire diagram below. Use wire nuts provided.
7. Using WIRE NUTS (local hardware item) make electrical connections: black BALLAST lead to hot
(black) supply lead; white BALLAST lead to neutral (white) supply lead. Green BALLAST lead is
ground wire and must be connected to grounding terminal or ground lead inside outlet box.
8. To wire incandescent unit: Using WIRE NUTS (local hardware item) connect black CORD wire to
hot (black) supply lead, connect white CORD wire to neutral (white) supply lead, green CORD wire
is ground wire and must be connected to grounding terminal or ground lead inside outlet box.
9. Attach CANOPY to CANOPY BRACKET with black CANOPY SCREWS.
BALLAST
OUTLET BOX
SCREWS
INSTRUCTI ON SHEET NO.
IS:406
B1004 Page 1 of 1
WIRE
NUTS
RELIEF
BUSHING
CANOPY
OUTLET BOX PLATE
KNOT
CANOPY
BRACKET
CORD
CORD
HINGE
MARK
120/277V
BLACK
Fig. 2
NEUTRAL
WHITE
RELIEF
BUSHING
CANOPY
BRACKET
THREADED INSERTS
RETAINER CUP
SHADE
GREEN
BALLAST
WIRE DIAGRAM
O-RING
GREEN
GREEN (OUTLET BOX PLATE GROUND)
GREEN
RE D RED/WHITE
RED RED
BLUE BLUE
BLUE BLUE/WHITE
CORD
GLASS SHADE INSTALLATION (fig.3)
1. Insert RETAINER CUP through top
of glass SHADE.
2. Place O-RING over RETAINER
CUP.
3. Align RETAINER CUP with
THREADED INSERTS in socket
plate.
ALUMINUM REFLECTOR INSTALLATION (Fig. 4)
1. Peel ADHESIVE BACKING off of 3 GASKET STRIPS. Apply
2. Insert RETAINER CUP through top of REFLECTOR and align with
3. Secure with 8-32 screws.
CANOPY SCREWS
Fig. 1
CAUTION: MAXIMUM WATTAGE AS MARKED
ON LUMINAIRE MUST NOT BE EXCEEDED.
THREADED INSERTS
RETAINER CUP
GASKET STRIP
REFLECTOR
8-32 SCREWS
Fig. 4
GASKET STRIPS, equally spaced, to lip of RETAINER CUP.
THREADED INSERTS in socket plate.
ADHESIVE BACKING
8-32 SCREWS
Fig. 3
A
COMPANY
rport Road, Fall River, MA
Loading...