Lightolier IS-2005 User Manual

lNsTR1 lcTlmJ SI.IFFT Nn

-------- .,-..-, ,-- .,.-

\

INSTALLATION OF LYTECASTER REFLECTOR TRIM

IN THE 2000 SERIES FRAME-IN-KIT WITH ROTO CLIPS

IS:2005

1088

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and 10caI or fe&ral

code specifications. To prevent electrical shock, turn off electricity at fuse box before proceeding,

Retain these instructions for maintenance referenoe.

FIG. A

1. FRAME-IN

FIG. B

2. ROTATE CLIPS

FIG. C

4. sNAP.ot4

FIG. D

4. PUSH-UP

WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR

WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

1. FRAME-IN (Fig. A)

See Frame4n-Kit instruction Sheet for installation

procedure,

2. ROTATE ROTO-CLIPS (Fig. B)

As shown in Fig. E.

3. SNAPON (Fig. C)

Insert SOCKET CUP in neck of REFLECTOR, Make
sure SPRINGS of SOCKET CUP snap into SLOTS of
REFLECTOR.

4. PUSH-UP (Fig. D)

Push REFLECTOR TRIM straight up until it is tight
against ceiling.

NOTE To remove REFLECTOR TRIM turn

REFLECTOR TRIM counterclockwise while !xllina
downward.

f<

F

WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF OTHER

MANUFACTURERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD
CONSTITUTE A FIRE HAZARD.

U.S. PATENT NOS, 4,029,822;4,313,754md 4,327,403

FOREIGNPATENTSPENDING.

PIN SLOT 2006 AND PINHOLE 2011

1. Make sure power is OFF.

2. Remove FACEPIATE from REFLECTOR TRIM. Pueh
up REFLECTOR TRIM tight against ceiling.

9. Lamp fixture with the recommended Ihrnp es
specified in REFLECTOR TRIM.

4. Push up FACEPLATE into REFLECTOR TRIM (Fig. F,
G).
NOTE For Pin Slot No. 2006 make sure SLOT in
FACEPLATE is in line with the adjueted Ikrnp position

(Fig. H),

REFLECTOR TRIM

FACEWATE

f 7

CKET CUP

‘Mp ‘OLDER

~

& APERTURE TRIM

-

ASSEMBLY

R6FLFC70RTRIM-

FACEpbITE

SLOT

%

m R

Y

FIG. F

\

\\

FIG. G

L

SLOT