Lightolier IS-2002 User Manual

READANDUNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE

‘hisfixlureisintendedforinstallationinaomdancewilh the National Electrical Code and

o assure

Iatallation,To preventelectricalshock,tum off electricityat fuseboxbeforeproceeding,

fullmmpliancewithIosdcodesand regulations,deck withyourlocalelecfricelinapecforbefore

Retaintheeeinstructionsfor maintenancereference.

local regulation.

lNSTRUCllON SHEET NO.

IS:2002

ROS92

INSTALLATION PROCEDIJRE FOR FRAME-IN KIT (NEW CONSTRUCTION ONLY)

FIG. B FIG. C FIG. D

FRAME-IN

1,

‘GA g 5’” ~ ,

WARNING–(RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR

WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

1.

2. CLOSE-IN

3. SNAP-ON

4, PUSH-UP

2.

NOTE: For wet plaster ceiling, use
Plaster Ring Accessory No. 1959
(order separately),

3. SNAP-IN (Fig. C). ~F:/~’$’flT~lM

4. PUSH-UP (F@. 0). SHEETS,

INSTRUCTION

1

‘w

,, ~ ROTO-CLIP

&

FIG. G

U.S. PA TENT NO. 4,039,822.
OTHER u.S. AND FOREIGN PA TENTS PENDING.

WARNING:USE ONLY REFLECTORTRIMS PROVIDED BY LIGHTOLIERINC. USEOF OTHER

MANUFACTURERS’REFLECTORTRIMS VOIDS THE UNDERWRITERSLABORATORIESLISTING

AND COULD CONSTITUTEA FIRE HAZARD.

1.1<5

I“ITC>I.IE R“ Ri:%%iwun;