Lightolier GO2 Retro User Manual

GO2 Retro

High Efficiency Fluorescent

Lightolier is a Philips group brand

GO2 Retro

GO2 Retro features a flat white louver

and a unique power tray that can be used
to convert most installations of 2'X4' or

The four main components of our GO2 Retro. The GO2 Retro Power Tray, GO2 Retro
Louver and two GO2 Retro End Adaptors.

2'X2' parabolic or specification grade lens
troffers, that are at least 4 3/8" deep, to state of the art, energy saving GREEN FIXTURES.
GO2 Retro is over 80% efficient with a broad light distribution that will illuminate both
horizontal and vertical surfaces, creating a comfortable balanced brightness.

Retrofitting with GO2 Retro as opposed to installing new fixtures is ideal for those areas
where you would like to have a minimum of down time such as retail spaces or schools.

42 GO2 Retro 2' x 4' 60' x 56' x 9' Room

Catalog Number

GOR2G232UNVC5*

Instan t star t ballast, 2-T8 3100 lumen lamps

GOR2G232UNVC2

Instan t star t ballast, 2-T8 3100 lumen lamps

GOR2G232UNVCO

Instant start ballast, 2-T8 3100 lumen lamps

* This layout of GO2 Ret ro will consume 10% to 4 0% less ene rgy than the current LEED requirement of 1.0 watts per squ are foot depending o n the ballast used.
Footcandle readi ngs are 2 1/2 ft off the floo r 2 1/2 ft on center.

1058 GO2 Retro 2' x 4' 376' x 280' x 16' Room

Catalog Number

GOR2G232UNVC2

Instan t star t ballast, 2-T8 3100 lumen lamps

GOR2G232UNVCO

Instan t star t ballast, 2-T8 3100 lumen lamps

* This layout of GO2 Ret ro will consume 28% to 46% less energy than the current LEED requirement of 1.0 watts per square foot depending on the ballast used.

Performance

Footcandle readi ngs are 2 1/2 ft off the floo r 2 1/2 ft on center.

Ballast

Factor

0.77 84.5% 0.67 48.4 1.3 : 1 48 0.60

0.87 84.5% 0.76 55.9 1.4 : 1 54 0.68

1.18 84.5% 1.03 74.0 1.3 : 1 72 0.90

Ballast

0.87 84.5% 0.76 46.4 2.58 : 1 54 0.5 4

1.18 84.5% 1.03 52.7 1.5 : 1 72 0.72

Factor

Efficiency

Efficiency

Total Light

Loss Factor

Total Light

Loss Factor

Reflectance 80/50/20

Average

Footcandles

Reflectance 80/50/20

Average

Footcandles

Uniformity

Uniformity

Max/Min

Max/Min

Input Wat ts

Input Wat ts

Watts/
Sq. Ft.

Watts/
Sq. Ft.

Energy

Savings

40%

33%

10

%

Energy

Savings

46%

28

%

Catalog Number

GOR2G217UNVHI

GOR2G214UNVPG

GOR2G224UNVPG

GOR2G217UNVC2

GOR2G232UNVHI

GOR2G232UNVC5

GOR2G228UNVPG

GOR2G254UNVPG

* Catalog number includes Advance Optanium high efficiency low watt ballast and Philips Alto Advantage
3100 lumen Lamps. GO2 Retro 2x2 is not available with an Emergency Pack option. Consult your

Ordering

Lightolier Sales Team.

Number of LampsFixture Size Lamp Type Ballast Type Ballast Factor

2 17W T8 Instant Start 0.872' X 2'

2 14W T5 Program Rapid Start 0.872' X 2'

2 24W T5HO Program Rapid Start 1.12' X 2'

2 32W T8 Instant Start 0.872' X 4'

2 32W T8 Instant Start 0.872' X 4'

2 32W T8 Instant Start 0.772' X 4'

20.9528W T52' X 4' Program Rapid Start

2 54W T5HO Program Rapid Start 1.02' X 4'

Installation of the G02 Retro

The first step in installation, after making sure power to fixture is disconnected, is to
remove all existing components of the previous fixture, leaving only the body. Place
the GO2 Retro End Adaptors between the base of the fixture and the T-Bar. Secure the
GO2 Retro End Adaptors in place with the supplied tech screws (4).

Lift GO2 Retro Power Tray into position. Slide GO2 Retro Power Tray into brackets
on End Adaptors.

Hang GO2 Retro Power Tray on tab and slot as shown above. Using the ballast
disconnect supplied (accepts up to 12 gauge wire), make power connections and
ground connection to body.

Slide the telescoping end of the GO2 Retro Power Tray into place, resting on the End
Adaptors. Tighten the integrated white thumb screws of the GO2 Retro Power Tray
securing it in place.

Insert the GO2 Retro Louver pins into the louver slots of the GO2 Retro End Adaptors
and close.

For more information regarding the GO2 Retro please consult specification sheet A10-32.

The installation of our GO2 Retro

is complete.

Lightolier is a Philips group brand

631 Airport Road
Fall River, MA 02720
Phone [phone]
Fax [phone]
www.lightolier.com

3015 Rue Louis Amos
Lachine (Quebec) H8T 1C4
Phone [phone]
www.canlyte.com

© 2008 Philips Group.
All rights reserved. Certain
products illustrated in this
catalog may be protected
by applicable patents and
patents pending. Lightolier
will aggressively defend all
of its intellectual property.
We reserve the right to
change details of design,
materials and finishes.

A.I.A. Division 16
Brochure LOL7121
Folio A10-30

Some luminaires use fluorescent
or high intensity discharge (HID)
lamps that contain small amounts of
mercury. Such lamps are labeled
“Contains Mercury” and/or with the
symbol “Hg.” Lamps that contain
mercury must be disposed of in
accordance with local requirements.
Information regarding lamp recycling
and disposal can be found at
www.lamprecycle.org.

Printed in the U.S.A.