Lightolier E7059 User Manual
INSTRUCTION SHEET NO.
INSTALLATION OF CALCULITE REFLECTOR TRIMS
INSTRUCTION SHEET FOR ITEMS
G7057, E7059, F7060
IS:E7059
0888
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications. To prevent
electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
~— L
&,
r
FIG. 1
A. FRAME.IN
FIG. 2
B. SNAP.IN
ECTOR
HOUSING
m
)
FIG. 3
C. PUSH.IN
WARNING+RISK OF FIREIDO NOT INSTALL1NSULATIONWITHIN3 INCHESOF FIXTURESIDESOR
WIRINGCOMPARTMENT,NOR ABOvE FIXTUREIN SUCII A MANNERSO AS TO ENTRAPHEAT.
A. FRAME4N (FIG. 1)
See Frame-In-Kit Instruction Sheet (No. IS:E61O) for
installation procedure.
B.SNAPIN (FIG. 2)
NOTE:
TRIM RING on over REFLECTOR HOUSING, as
shown on Fig. 4 and 5, before Snap-in. For
Flangeless Trim installation, WHITE TRIM RING is
not required.
Fasten ADJUSTABLE SOCKET HOUSING to
REFLE~OR/HOUSING by pushing ADJUSTABLE
SOCKET HOUSING into REFLEC70R/HOUSING for
engagement. Engage SPRING to desired
LAMPiVVAITAGE position (see label on inside and
outside of neck of REFLECTOR/HOUSING.
See Fig. 6.
For Overlapping Trim installation slip WHITE
B:7’g@
SLOT
FIG. 4
ADJUSTABLE SOCKET
HOUSING
FIG. 5
C. PUSH-IN (FIG. 3)
Push OPTICAL SECTION straight up into
MOUNTING FRAME until tight against finished
ceiling. RETAINING SPRINGS on MOUNTING
FRAME (Fig. 1) will secure OPTICAL SECTON
(reflector or baffle) in place.
NOTE To remove, rotate REFLECTOR/HOUSING
counterclockwise while pulling downward. After
starting, use both hands to remove. See Fig. 7.
CARE AND MAINTENANCE OF “ALZAK” REFLECTOR
If handling of reflectors with anodized or Alzak finish is
required, the use of clean white or plastic film gloves is
recommended to avoid fingerprints.
SPRINGS
FIG. 6
—
~ed:~~ or Alzak surfaces can be cleaned by the following
1.
Wipe of with a soft, clean, dry, lint-free cloth.
TO REMOVE
2. Wipe off with a clean cloth dampened in mild detergent
solution. Rinse, then wipe dry with lint-free cloth or paper
towel.
3. Wipe off with a clean cloth dampened with a solution of
wetting agent and water (such as 2 oz. per gallon
“Pluronic L62-LF by Wyandotte Products), or a liquid wax
such as Glass Wax”. Then wipe dry. Avoid gritty cleaning
m
(
FIG. 7
agents.
US. Pat. No. 4,039,822
L I <3 H Tc> 1-1 E R“ :Y:::::L,N::EV::, E:A:P:J
Loading...