Lightolier Dorm Lyte User Manual

Wall Mounted Fluorescent Dorm Lyte

Page 1 of 2 6" Width, 48" Nominal Length

1 or 2 Lamp T5 or T8

• For dorms, nursing homes, assisted living, health care facilities, or
other over bed or wall mounted applications.

• Up and downlight, 1 or 2 lamp.

• Separate lamp compartments for controlled uplight and downlight.

• 1/8" thick DR acrylic lens.

Unique co-extension.
White opaque center.
Frosted white front sections for subtle glow.
Linear prisms to spread up/downlight.

• Only 3-7/8" deep, meets American With Disabilities Act
for wall mounted fixtures.

• Concealed pull-action spring-loaded latches to retain lens.

• 20 gauge cold rolled steel post painted baked white
enamel end caps.

• Nominal 4' length.

• Four-way pull switch, (120 volt only) optional.

• Optional low voltage electronic sequential switch for push button
control of up/down lighting. UL 544 listed. Includes phone jack type
receptacle.

Features Dimensions

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Volts/Ballast:

Lightolier a Genlyte company www.lightolier.com

Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2006 a Genlyte company Section 4A/Folio I60-10

4/06

6" (152mm)

3-7/8 (95mm)

Up/Downlight

Uplight or Downlight

4"

(102mm)

6"

(152mm)

24"

(610mm)

47-15/16

(1218mm)

6" (152mm)

3-7/8 (95mm)

0.0 45.0 90.0 FLUX

0 465 465 465

5 479 455 455 44
15 531 425 420 126
25 581 375 368 190
35 615 311 301 237
45 630 241 228 261
55 623 168 153 254
65 589 108 95 235
75 548 55 48 203
85 504 14 10 172
90 496 12 0
95 514 32 13 184

105 558 77 55 223
115 598 132 107 257
125 623 195 170 278
135 630 261 237 278
145 615 326 304 252
155 581 384 365 201
165 531 425 412 128
175 470 446 442 43
180 448 448 448

Lightolier a Genlyte company www.lightolier.com

Technical Information: [phone] • Fax [phone]
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
© 2006 a Genlyte company Section 4A/Folio I60-10

Job Information Type:

Options/Accessories

Fusing: Internal fast blow fusing: SUFFIX: GLR.

Internal slow blow fusing: SUFFIX: GMF.
Radio Interference Filter: 120 or 277 volt, 50 or 60 Hz. One per fixture. SUFFIX: R.
One per Ballast, SUFFIX: B.
Electronic (Low Voltage) Sequential Switch: Switch factory mounted for Up and

Down Light operation from pillow switch. Includes phone jack type receptacle.
SUFFIX: SW.
Momentary Button Cordset: Traditional "Winged" Pendant design ESD protection
to 15,000 volts. Heavy duty 7' cable with phone plug and security clip.
Consult factory: Part number 7800W-7 CSP. (Button Cordset can only be used with
SW Sequential Switch option)

4-Way Pull Switch: SUFFIX: 4P.
Electrical Wiring Options: Consult factory.

Specifications

Materials: Chassis parts are die-formed code rolled steel. End Caps–20

gauge cold rolled steel. Refractor–1/8" thick DR acrylic, unique co-extrusion,
white opaque center, linear prisms to spread up/down light.

Finish: exterior white baked acrylic enamel.
End Caps and Cover–Post painted baked white enamel, 86% reflectance.

Phospate undercoating.

Wall Mounted Fluorescent Dorm Lyte

Page 2 of 2 6" Width, 48" Nominal Length

1 or 2 Lamp T5 or T8

Model No. DL4X232120SO

LER = FP - 58.6 IW - 53.1 BF - 0.88
Comparative yearly lighting energy cost per

1000 lumens = $4.10

Report Number: G2006054
Lamp: F32T8
Luminaire: Up/down Wall Mounted with

Two Color Co-extruded Lens

Ballast: B232

IUNVHP-B

Report is based on 2950 Lumens per lamp.
Efficiency: 60.4%
CIE Type-Direct-Indirect

Plane: 0-Deg 90-Deg 180-Deg.
Spacing Criteria: 1.9 1.1 1.1
Shielding Angles: 55 65
Luminous Length: 48.000 2.400
Height of Side 6.000 6.000

CANDELA DISTRIBUTION

0

AVERAGE AVERAGE AVERAGE AVERAGE

IN DEG. 0-DEG. 45-DEG. 90-DEG.

45 10652. 1310. 3855.
55 12396. 862. 3044.
65 014783. 540. 2384.
75 019419. 277. 1701.
85 032024. 73. 635.

LUMINANCE DATA IN CANDELA/SQ. METER

COEFFICIENTS OF UTILIZATION –

ZONAL CAVITY METHOD. EFFECTIVE
FLOOR CAVITY REFLECTANCE 0.20

0

RC 80 50 30

RW 70 50 30 50 30 10 50 30 10

01585452424038343332
02524743363331292725
03474136312825262321
04433631282421232018
05393227252118201715
06362823221816181513
07332621201614161412
08312318181512151210
09292116171311141199

10 27 19 15 15 12 10 13 10 88

ZONE LUMENS % LAMP % FIXT

00-030 359 6.1 10.1
00-040 596 10.1 16.7
00-060 1112 18.8 31.2
00-090 1723 29.2 48.3

90-120 664 11.3 18.6
90-130 942 16.0 26.4
90-150 1472 25.0 41.3
90-180 1843 31.2 51.7

00-180 3566 60.4 100.0

ZONAL LUMEN SUMMARY

Ordering Information

Explanation of Catalog Number. Example: DL4X232120SO

DL

Options:

Add appropriate
suffix to catalog

no., ie: (GLR)

Dorm Lytel:

Wall Mounted

Fluorescent

Lamp

Quantity:

1=1 Lamp
2=2 Lamp

Ballast Type:

<20THD <10THD

1 or 2 Lamp 32W Elec. T8 SO * H

I *

1 or 2 Lamp 28W Elec. T5 –P

I †

1 or 2 Lamp 28W Elec. T5 – †PG ††
1 or 2 Lamp 54W Elec. T5 – †PG ††

(Nominal 48")

LOL T8 Dimming PS* –
*Instant Start Standard

†Instant Start (120 or 277)
††Program Rapid Start (UNV only)

NOTE:
For T8 UNV, you must use H

I Ballast Code.

Voltage:

120, 277 or UNV

UNV=120-277

Lamp Type:
32=32W T8
28=28W T5
54=54W T5

4

Fixture
Length:

4=48"

X = Up/Down Light
R = Independent

Up or Down
Light . (2 lamp
only)

Room Size: 12' x 10' x 8' Ceiling.
Reflectance: 80-50-20 .80LLF
Reading Area: 35-40fc

15 35 52 35 15

15 25 31 35 15

12 14 16 14 12

9 101010 9

88887

77777

1'

3'

5'

7'

9'

11'

1' 3' 5' 7' 9'

3'

5'

3'6"

Reading

Plane

35 to 40 fc
reading plane
(60° from horizontal)

reading position

Specifications (continued)

Electrical: Thermally protected class “P” ballast CBM approved, non PCB. If

K.O. is within 3" of ballast, use wire suitable for at least 90°.

Labels: I.B.E.W./UL and ULc Listed.