Lightolier A0100 User Manual

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTIONS FOR INSTALLATION OF DISCUS FIXTURES

INSTRUCTION SHEET NO.

IS:6700

A0100 Page 1of 1

1. Twist DIFFUSER counterclockwise and remove.

2. Partially thread supplied MOUNTING SCREWS into OUTLET BOX.

3. While supporting FIXTURE HOUSING, make electrical
connections: black fixture lead or fixture lead without tracer
marks to hot (black) supply lead; white fixture lead or fixture lead
with tracer to neutral (white) supply lead. Green fixture wire is a
ground and must be connected to grounding terminal or ground
lead inside OUTLET BOX. Use WIRE NUTS (local hardware item).
Push connections back into OUTLET BOX.

4. Position FIXTURE HOUSING over MOUNTING SCREWS and allow
heads of MOUNTING SCREWS to come through KEYHOLE SLOTS
in FIXTURE HOUSING. Turn FIXTURE HOUSING until SCREWS
fully engage in narrow portion of KEYHOLE SLOTS and secure in
place by tightening MOUNTING SCREWS.

5. Install recommended lamp(s).

CAUTION: MAXIMUM WATTAGE AS MARKED ON

FIXTURE MUST NOT BE EXCEEDED.

6. Re-install DIFFUSER to FIXTURE HOUSING. Align the three
bracket tabs with details in DIFFUSER, then rotate clockwise.

OUTLET BOX

GROUND WIRE

WIRE NUT

FIXTURE HOUSING

MOUNTING SCREWS

REFLECTOR ASSEMBLY

KEYHOLE SLOT

REFLECTOR SCREW

SHADE (IF PROVIDED)

RETAINING
CLIP

Fig. 1

DIFFUSER
NOTCH

OPEN

Fig. 2

DIFFUSER

DIFFUSER
MOUNTING
TAB

PROTRUSION

LOCK

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720