Lightolier 8672 User Manual
F
INSTRUCTION SHEET NO.
.
INSTRUCTIONS FOR CONNECTING LYTEJACKS FIXTURES
TO 8600 SYSTEM POWER JACKS.
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local electrical
inspector before installation. To prevent electrical shock, turn off electricity at fuse box before
proceeding.
Retain these instructions for maintenance reference.
NOTE: Use this Focal Jack with a 50 watt Power Jack.
1. Turn power off. Insert the top of the STEM (Fig. 1) fully into the POWER JACK RECEPTACLE. Verify
engagement by exerting a LIGHT DOWNWARD pull. The STEM should not release from the POWER
JACK.
2. To remove the fixture, grasp the STEM and FIRMLY pull DOWNWARD until STEM is disengaged from
the SOCKET RECEPTACLE.
FIXTURES ARE DESIGNED FOR 360° HORIZONTAL ROTATION and 0° TO 90° VERTICAL ADJUSTMENT.
IS:8672
0989 Pagel of2
TYPICAL POWER JACK
Q
P
FIG. 1
SEE BACK FOR LAMPING
INSTRUCTIONS FOR LAMPING
1S:8672
0989
Page 2 of 2
1. Check to see that power is OFF before Iamping or
relamping.
2. Remove APERTURE BAFFLE from HOUSING by
pulling straight out as shown in Fig. 2.
3. Assemble LAMP to APERTURE BAFFLE as shown
in Fig. 3 making certain GLASS LAMP GUARD is
sandwiched between LAMP and APERTURE
BAFFLE, and firmly held in placce by LAMP
SPRINGS. CAUTION: Do not touch lamp capsule
with bare fingers.
4. Connect SOCKET to LAMP by inserting pins on
LAMP into holes in SOCKET (Fig. 3).
Replace APERTURE BAFFLE back into HOUSING
pushing straight in.
by
WARNING: LAMP MANUFACTURERS
REQUIRE THE GLASS LAMP GUARD BE IN
PLACE BEFORE ENERGIZING LAM~ AND
THAT GREAT CARE SHOULD BE TAKEN
THAT LAMP IS FULLYCOOLED BEFORE
RELAMPING. COLOR FILTERCAN BE
USED
IN PLACE OF GLASS GUARD.
1
SOCKET
I
n
H
FIG. 2
HOUSING
APERTURE BAFFLE
NOTE: LOW VOLTAGE FIXTURES should be
dimmed only with special dimmers intended
specifically for that purpose. Use Lightolier
Lytemode, Scenist, Crescendo VA, Neptune VA,
Precision VAI, Easyset VA, Sunrise VA, Radiant
VA or equivalent products by others or variable
auto-transformers or electronic dimmers
intended for use with low voltage fixtures.
NOTE: Lamp wattage 50W max.
GLASS LAMP
Ell ADi_I
““”, ,”
d
T
IT CLAMP
1= BAFFLE
FIG. 3
LAMP SPRING
-
APFRTIJRE
,. !-,,,”
Loading...