Lightolier 8626WH User Manual
INSTRUCTION SHEET NO.
!NSTRUCTIONSFOR INSTALLATIONOF
L~EDROP FIXTURE
FOR USE WITH 8600 SERIES POWER JACKS ONLY
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these Instructions for maintenance reference.
IS:8626
1189
MOUNTING
1. If used with POINT POWER JACK #8605, use the cap marked “35W MAX’ If used with other POWER
JACKS, make certain that the STEM BUSHING is removed from the POWER JACK ENTRY (Fig. 2).
2. Screw the JACK ASSEMBLY fully into the POWER JACK (Fig. 2).
INSTRUCTIONSFOR LAMPING
CAUTION: MAKECERTAINTHATTHE
HENS QUICKLY, MAKE SURE THAT THE POWER IS DISCONNECTED BEFORE INSERTING LAMP
INTO THE LAMP SOCK=.
1,
SEPARATE
Lift the GLOBE ASSEMBLY (with STYLE JACK SHADE) while rotating to the LE~ until it is released from
the LAMP SOCKET ASSEMBLY (Fig. 1).
LYTEDROP FIXTURE IS COOL BEFORE HANDLING. SINCE THE IAMP
lN~ALL LAMP
2,
CAUTION: DO NOT TOUCH THE IAMP WITH BARE HANDS.
Oils from the hands could reduce L4MP life. Use tissue paper or a soft cloth. Insert the LAMP into the
SOCKET holes as far as it will go. Pins will be exposed approximately h“ outside of the SOCKET when
fully enaaaed. No ~olarity of Dins is required.
REASSEMBLE (Fig. 2).
3.
.-
I
.
NOTE: Lamp replacement:
Tungsten-Halogen, T-4
Bi-Pin 6.35 base 35W mex
LAMP SOCKET
/ ‘SSEMBLY
I LAMP (SEE NOTE)
GLOBE ASSEMBLY
/
POWER JACK ENTRY
JACK ASSEMBLY
~35wMAx.cAp
-/II
1[
STEM
69
o
STEM BUSHING
REMOVED
OR
FIG. 1
\
‘--------
TO SEPARATE
NOTE: THE STEM
CONCEALED FLEX
ABSORB IMPACT.
HAS A
TO
FIG.
TO REPLACE
Loading...