Lightolier 7920 User Manual

r

E[$~~~~i,N~~~~~s

READAND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This

fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION OF THE SLOPED CEILING ADAPTER FOR

(1)

RecessedDuo-CastTrim Calculates
(2)RecessedModular Frame-h Calculates
(3)

RecessedH.I.D.Downlights

INSTRUCTIONSHEETNO.

Y

IS:7920

R0394 Page 1 of2

I-I

C5 H TC> L I E R“

d

NSTRUCTIONSHE~ NO.

1S:7920

W384

Page2 of2

INSTALLATION OF THE SLOPED CEILING ADAPTER (Continued)

FIG. 6

!!

b. Attach DUO-CAST TRIM FRAME to SLOPED

CEILING ADAPTER with flange

(4) PHILLIPS HEAD POINTED SHEET METAL

SCREWS. See Fig. 6 and instruction 3.

B. For Modular Frame-In Calculates:

a. Secure MODULAR DIE-CAST RING to SLOPED

CEILING ADAPTER by tightening (4) PHILLIPS HEAD
POINTED SHEET METAL SCREWS. See Fig. 7 and

instruction 3.

C. For Recessed H.I.D. Downlights without Duo-Cast Trim:

a. Detach Lightshield (cone, Multi-Groove or reflector)

from fixture. See instruction sheet packed with
fixture.

b. Secure SLOPED CEILING ADAPTER to the HOUSING

SUPPORT by tightening, from inside of fixture, the

(4) PHILLIPS HEAD POINTED SHEET METAL

SCREWS as shown in Fig. 8.

NOTE For EL8 fixture series bend(4) TABS 90°

outward from NOTCHES to center HOUSING

SUPPORT in SLOPED CEILING ADAPTER. Then

secure with (4) WASHERS though NOTCHES
shown in Fig. 9.

D. For Calculite and Recessed H.I.D. Downlights with

flangless Sheet Metal Trim Ring:

a. Detach SHEET METAL TRIM RING from fixture (see

instruction sheet packed with fixture).

b. Attach SHEET METAL TRIM RING to SLOPED

CEILING ADAPTER by tightening (4) PHILLIPS HEAD
POINTED SHEET METAL SCREWS. See Fig. 10 and

instruction 3,

down, by tightening

PHILLIPS HEAO POINTEO _
SHEET METAL SCREWS (4)

FIG. 7

FIG.8

PHILLIPSHEAO
POINTED SHEET
METAL SCREWS (4)

WASHER

H.I.O. HOUSING SUPPORT

BRACKET (4) RIVETED
TO SLOPED CEILING
AOAPTER

PHILLIPS HEAD POINTEO
SHEET METAL SCREWS (4)

Ii’

/

TlltE

ouo-cAsTTR\M FRAME

(FLANGE OOWN)

MOOULAR OIE-CAST RING

\

A

/

SLOPEOCEILING
ADAPTER

~

-- SLIJPE’OCEILING ADAPTER

\

\ ,, II

WHITE MOLDEO RING

MULTI-GROOVE
OR REFLECTOR

;. AfLer complete installation, replace white molded ring (if

any) and Lightshield (cone, Multi-Groove or reflector). See

instruction sheet packed with fixture.

PHILLIPS HEAD POINTED ‘“
SHEET METAL SCREWS (4)

k

SLOPEO CEILING AOAPTER

r--

FIG. 9

SLOPEO CEILING
AOAPTER

H.I.O. HOUSING