Lightolier 6422MC User Manual

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTIONS FOR ATTACHING LYTESPOT®TO LYTESPAN®TRACK

For use with Lytespan®Track Systems Only

INSTRUCTIONS FOR ATTACHING LYTESPOT®TO
SINGLE CIRCUIT TRACK SYSTEMS

1. Insert into LYTESPAN TRACK. (Fig. 1) LOCKING LEVER
must be on the same side of track as BEAD.

2. Rotate FITTING clockwise until LOCKING LEVER snaps
and locks in place. (Fig. 2 & 3)

3. To remove: depress LOCKING LEVER, then rotate FITTING
90° counterclockwise.

LYTESPAN TRACK

INSTRUCTION SHEET NO.

I S : 6 4 2 2 M C

0498 Page 1 of 2

BEAD

FITTING

LOCKING

LEVER

Fig. 1

INSTRUCTIONS FOR CONVERTING LYTESPOT

®

ATTACHMENT FITTINGS TO OPERATE ON 2
CIRCUIT TRACK

See Fig. 4. BRASS CONTACTcan be raised or lowered.
Broken line indicates position for 1 circuit or lower circuit
of 2 circuit track system.

To convert attachment FITTING for upper circuit of 2 circuit
track, raise BRASS CONTACT to high position by lifting
CONTACT as high as stop permits and CONTACT clicks
into place.

Fig. 2 Fig. 3

BRASS CONTACT

LOCKING
LEVER

Fig. 4

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

WARNING: LIGHT FIXTURE and L A M P get extremely

hot during operation. Allow FIXTURE to cool before
handling.

INSTRUCTION SHEET NO.

I S : 6 4 2 2 M C

0498 Page 2 of 2

INSTRUCTIONS FOR LAMPING (Fig. 5 & 6)

1. Remove LOUVER by pulling straight out. (Fig. 5)

2. WARNING: RISK OF FIRE

Use only T-4 Tungsten – Halogen outside frosted
minican base L A M P, 150 watts maximum. Insert L A M P
into S O C K E T. Turn clockwise until tight. To remove, turn
counterclockwise. (Fig. 6)

3. Replace LOUVER with GLASS LAMP GUARD in place by
pushing straight up until LOUVER is flush with FIXTURE
HOUSING.

WA R N I N G: Lamp manufacturers require the

GLASS LAMP GUARD be in place before energizing
L A M P, and that great care should be taken that
LAMP is fully cooled before relamping.

HOUSING

GLASS LAMP

GUARD

Fig. 5

LOUVER

HOUSING

T-4 LAMP

Fig. 6

SOCKET

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720