Lightolier 6336 User Manual

/

&KNoB

INSTRUCTIONS FOR AITACHING LYTESPOT” TO

LYTESPAN” TRACK

FOR USE WITH LWESPAN” TRACK SYSTEMS ONLY
READ

This fixture is intended for installation in accordance with the National Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.
INSTRUCTIONS FOR AITACHING LYTESPO~

TO SINGLE CIRCUIT TRACK SYSTEM

1. Align BEAD on LYTESPAN TRACK and GROOVE in FIT-

AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

TiNG before inserting into LYTESPAN TRACK. See Fig.

1. (if BEAD is NOT aligned, a potentiai hazard may
result.)

INSTRUCTION SHEET NO.

IS:6336

R0490

.m.m

2. Position LEVER as shown in Fig. 1.

3. To attach FiTTi NG, insert into LYTESPAN TRACK. Turn
LEVER 90° whiie pushing upward on fitting, to make
mechanical and electrical connection. See Fig. 2.

4. To remove or shift fixture location on the LYTESPAN
TRACK, reverse procedure as described in #3 above.

5. To aim fixture, first loosen the KNOB by turning it

counterclockwise. Position to the desired angle, then
tighten KNOB.

GROOVE

FllTING

– LEVER

m

FIG. 1

NOTE: Lamp manufactures’ bulb sleeve may state “Burn

oniy in porcelain sockets.” in certain fixtures phenoiic,
not porcelain, socket are used. These are of a speciai
heat resistant type that have been tested by Lightolier
and are listed by Underwriters Laboratories for use with
the recommended lamps.

INSTRUCTIONS FOR CONVERTING LYTESPOT@
Attachment FllTING TO OPERATE ON
2 CIRCUIT TRACK

NOTE:

LOWER

UPPER

To insure proper operation of Lytespots on
Two Circuit Lytespan Track, the BLACK SPACER
(provided) must be used at aii times on the

piug assembiy.

The BLACK SPACER is not used when operating

Lytespots on Singie Circuit Track.

CIRCUi~ FIG. 3:
Illustrates contacts in low position with spacer in

place for lower circuit.

CIRCUIT, FiG. 4 and 5:

To convert attachment fitting for upper circuit, raise
BRASS CONTACT to high position (as indicated by
dotted line) by pulling CONTACX as high as stop

permits and slipping on BLACK SPACER as shown

in Fig. 4 and 5.

&

FIG. 2

KNOB