Lightolier 6194 User Manual
●
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
rhis fixture is intended for installation in accordance with the National ElectricalCodeandlocalregulations.
roassurefull compliance with local codes and regulations, checkwith your local electrical inspector before
nstallation. Toprevent electrical shock,turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONSHEETNO.
IS:6194
A1294
Page 1 of 1
INSTALLATIONS FOR WALL MOUNTING MONOPOINT PIN-UP
IMPORTANT SAFETY INSTRUCTIONS
This product has a polarized attachment plug (one blade is wider than the other). As a safety feature, this plugwill fit in a polarized
outlet only one way. If the plug does notfitfully in the outlet, reverse the plug. If it doesnotfit, contact a qualified electrician.
Never use with an extension cord unless the plug can be fully inserted. Do notattemptto defeat this safety feature.
CAUTION- INJURY TO PERSONS AND DAMAGE TO THE LAMP ANDIOR MOUNTING SURFACE MAY RESULTIFTHELAMP
IS PULLEDFROMTHE SURFACE.TO REDUCETHELIKELIHOODOFSUCHINJURY ORDAMAGE, MOUNT ONLYONA SURFACE
THAT IS MECHANICALLYSOUND.
1.Locate MOUNTING PLATE in desired location and mark holes
with pointed tool to start screws (top edge of bottom clip
opening is center of MONOPOINT PIN-UP). See Fig. 1.
2. Screw MOUNTING PLATE to wall using screws supplied.
NOTE: a. It is best if screws are installed directly into a
stud behind wall.
b. MOUNTING PLATE can be mounted directly on
sheet rock, provided screws are not over-
tightened.
c. If mounting surface is other than sheet rock (brick,
concrete, laminated building materials or the like),
toggle bolts or plastic anchors should be used.
f’
.i
/
./’
MONOPOINT PIN-UP
1
3. After MOUNTING PLATE is installed, clip on MONOPOINT
as shown in Fig. 2 and plug into nearest outlet.
PIN-UP
4. Install lighting unit as per instructions supplied.
PUSH
DOWN
I
FIG.2
c
-
1
+.
[
-4
%.
%
$
FIG.1
‘@’
1
d
CENTER
LINE
-
Im I
C5H iCX IE R“z~~~~~~;8N~
Loading...