Lightolier 6088 User Manual

lNSTRIJCTION SHEET NO,

IS:6088

SLOITED GRID CEILING CLIPS

FOR USE WITH BASIC OR ADVENT L~ESPAN” TRACK SYSTEMS ONLY

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for reference.

0291

SLOITED GRID CEILING SYSTEM
SUCH AS DONN FINELINEP
AND CHICAGO METALLIC ULTRALINE” 3500.

“ L<%,..

%8”

?

FIG. 1

1. Use 2 clips for 2’ and 4’ track units. Use 3 clips for 8’ track unit.

2. Assemble the clip to the TRACK MOUNTING CLIPS (supplied with the track).

3. Thread the NUT to the top of the screw. See Fig. 2.

4. Place one side of the NUT in the SLOTTED GRID RUNNER and snap the other side in by pushing up on
the screw. See Fig. 3.

5. Tighten SCREW to the point that the TRACK MOUNTING CLIP is tight against the runner but can still
be rotated. S~e Fig. 4.

6. Secure the TRACK UNIT by rotating the TRACK MOUNTING CLIP clockwise. See Fig. 5.

SCREW

TRACK MOUNTING CLIP

NUT

J

) 1

SLOITED GRID
RUNNER

&

1- I <5

TRACK MOUNTING CLIP

FIG. 2

SLOITED GRID
RUNNER

INITIAL

POSITION

ROTATECLOCKWISE

(lookingup from below)

FINAL

4

FIG. 4

SCREW

POSITION

FIG. 3

— MOUNTING

TRACK UNIT

FIG. 5

I“ric>m-lE R“:v:::::L,N: