Lightolier 6063 User Manual

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

lis fixture is intended for installation in accordance with the National Electrical Codeand local regulations.
I assure full compliance with local codes and regulations, check with your local electrical inspector before
lstallation. To prevent electrical shock,turn off electricity at fuse boxbefore proceeding.

Retain these instructions for maintenance reference.

INSTRUCTIONSHEET NO. 7

IS:6063

A1294

Page 1 of 1

SADDLE CANOPY KIT

FORUSEWITH 6000OR9100SERIESLIGHTOLIERLIGHTINGTRACKSYSTEMONLY

rhe Saddle Canopy Mounting Kit mounts to any point along the track for feeding power from an outlet box. Extra Dead End Cover is included
:0 replace LIVE END if desired.

CAUTION:TURN OFFPOWER AT FUSEBOX BEFOREINSTALLING TRACK.INSTRUCTIONSFOR GROUNDING MUST BE

FOLLOWED.FAILURETO DOSOMAY RESULTIN A HAZARDOUSCONDITION.

1, Attach CROSSBAR to OUTLET BOX as shown in Fig. 1.

2, Mount track to ceiling as shown in Instruction Sheet 6020 or

9100 bringing lead wires (#1 2 ga.) from OUTLET BOX

either side of track.

3. Insert FITTING into TRACK (see Fig. 2) with LOCKING LEVER on

same side of track as BEAD.

4, Rotate FITTING 90” clockwise until LOCKING LEVERsnaps into

place (see Fig. 2).

5. Make wiring connections: black to black, white to white, green
wire to grounding terminal or ground wire in OUTLET

or bare

BOX (see Fig. 3).

6. Insert wiring connections into OUTLET BOX (see Fig, 3).

7. Place CANOPY over FITTING, lineup

threaded holes in CROSSBAR, and fasten together with screws
(included). Make certain that wires do not interfere with proper

seating of CANOPY.

END maybe removed and replaced with DEAD END COVER

B. LIVE

(included).

holes in CANOPY with

down

oEAO END

COVER

\

TRACK

CENTERLINE

FITTING

CANOPY

CANOPY MOUNTING

SCREW

OUTLETBOX

(FLUSHWITH CEILING)

I

/“

—.!

FIG. 1

CROSSBAR

,Lo:pR& ~’

LOCKING LEVER

FIG.2

I FIG. 3

1- I

C: H TC>L I E 1? :::::::iN:=:f..:

CANOPY

.!